Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Synergetic utilization of microwave-modified fly ash and carbide slag for simultaneous desulfurization and denitrification

Synergetic utilization of microwave - assisted fly ash and carbide slag for simultaneous desulfurization and denitrification: High efficiency, low cost and catalytic mechanism

Simultaneous Desulfurization and Denitrification by Microwave Catalytic over FeCoCu/Zeolite 5A Catalyst

Plasma Catalytic Desulfurization and Denitrification Simultaneously over FeCo/zeolite

Disposal of Low Concentration Fume with Solid Waste Modified by Microwave.

Enhancing Simultaneous Desulfurization and Denitrification Efficiency of Cement Kiln Exhaust Gas Via Co-Catalytic Fenton Oxidation Process

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

Novel Method for High-Performance Simultaneous Removal of NOx and SO2 by Coupling Yellow Phosphorus Emulsion with Red Mud

Simultaneous removal of SO2 and NO by CO reduction over prevulcanized Fe2O3/AC catalysts

Study on Desulfurization and Denitration of with Industry Solid Waste by Microwave

Microwave Catalytic Desulfurization and Denitrification Simultaneously on Fe/Ca-5a Zeolite Catalyst

Fe-doped CeTiO x catalysts facilitate the oriented oxidation of NO to achieving simultaneous desulfurization and denitration in a WFGD system

An Adaptive Sorbent for the Combined Desulfurization/Denitration Process Using a Powder-Particle Fluidized Bed

Simultaneous Removal of NO and SO2 from Coal-Fired Flue Gas Based on the Catalytic Decomposition of H2O2 over Fe2(MoO4)3

Simultaneous Removal of SO2 and NO x Using Steel Slag Slurry Combined with Ozone Oxidation

Simultaneous Removal Of So2 And Nox From Sintering Flue Gas Using Ammonia-Fe(Ii) Edta Combined With Electrolytic Regeneration

High Efficient Removal Of So2 And No Of Flue Gas In A Single Fluidized Bed Reactor

A Superior Liquid Phase Catalyst for Enhanced Absorption of NO2 Together with SO2 after Low Temperature Ozone Oxidation for Flue Gas Treatment

The enhanced mechanism of Fe(III)/H 2 O 2 system by N, S-doped mesoporous nanocarbon for the degradation of sulfamethoxazole

Efficient calcium sulfite oxidation treatment by a highly active iron-manganese bimetallic metal-organic frameworks (MOFs)

The simultaneous removal of SO2 and NO from flue gas over activated coke in a multi-stage fluidized bed at low temperature