Abstract:Selective catalytic reduction technology is the most commonly used method for NOx control, but the preparation process of the catalysts is complicated and the preparation cost is high. In this study, a novel low-cost catalyst for selective catalytic reduction of nitrogen oxides was prepared by treating vanadium-bearing steel slag with calcination modification and sulfuric acid modification. The activity test results show that the calcination modification can slightly improve the high-temperature activity of the catalysts. Among acid-modified catalysts, sulfuric acid modification can greatly improve the denitration activity of the catalyst, and calcination of the catalyst before sulfuric acid modification can obtain a higher activity denitration catalyst. The NOx removal efficiency of VSS-C-S catalyst reached 82.4% at 250°C. In addition, the catalyst modified with sulfuric acid after calcination has better water and sulfur resistance and regeneration performance. In the case of high water vapor and sulfur dioxide concentration, its denitration efficiency is 62.5%. The characterization results show that both calcination modification and sulfuric acid modification can promote the formation of α-Fe2O3, but calcination modification reduces the specific surface area and redox capacity of the catalysts. The sulfuric acid modification can form a new pore structure and a large number of sulfate species on the catalyst surface, and improve the existing state of vanadium species in the catalysts. The specific surface area of VSS-C-S catalyst is 43.90m2·g-1. Meanwhile, the adsorbed oxygen content of VSS-C-S catalyst is 24% higher than that of VSS-S-5 catalyst. It shows that the modification effect of sulfuric acid can be better exerted by calcination first and then modification with sulfuric acid. The results of in-situ DRIFTS experiments show that the NH3-SCR reaction of the calcined modified catalyst mainly follows the L-H mechanism. The NH3-SCR reaction of sulfuric acid-modified catalysts mainly follows the E-R mechanism. The active sites on the VSS-C-S catalyst surface adsorb a large amount of NH3 species and activate them as NH2 active intermediates, which directly react with gaseous NO. Therefore, the catalyst modified with sulfuric acid after calcination has higher activity. The work provides a novel idea for reducing catalysts cost and promoting cleaner production.

Research on deeply modified Fenton sludge for the selective catalytic reduction of NO x : Promotion mechanism of acidification reorganization

Experimental Study on the NO Oxidation and Removal by Heterogeneous Fenton Reaction

Sludge Recycling from Non-Lime Purification of Electrolysis Wastewater: Bridge from Contaminant Removal to Waste-Derived NOX SCR Catalyst

Heteroatoms doped iron oxide-based catalyst prepared from zinc slag for efficient selective catalytic reduction of NOx with NH3

Sustainable disposal of Fenton sludge and enhanced organics degradation based on dissimilatory iron reduction in the hydrolytic acidification process

Investigation of modified carbon-based catalyst on low-temperature selective reduction of flue gas denitration performance

Denitrification of flue gas by heterogeneous Fenton reaction with Fe-based catalyst on different carriers

Enhancing Simultaneous Desulfurization and Denitrification Efficiency of Cement Kiln Exhaust Gas Via Co-Catalytic Fenton Oxidation Process

Experimental study on integrated desulfurization and denitrification of low-temperature flue gas by oxidation method

Catalytic reduction of nitrogen monoxide using iron–nickel oxygen carriers derived from electroplating sludge: Novel method for the collaborative emission decrease of polluting gases

Conversion of Fe-rich Waste Sludge into Nano-Flake Fe-SC Hybrid Fenton-like Catalyst for Degradation of AOII.

Sustainable Strategy for Enhancing Anaerobic Digestion of Waste Activated Sludge: Driving Dissimilatory Iron Reduction with Fenton Sludge

Effect of iron loading on the performance and structure of Fe/ZSM-5 catalyst for the selective catalytic reduction of NO with NH3

Ce(SO4)2/α-Fe2O3 selective catalytic reduction of NOx with NH3: preparation, characterization, and performance

Ultrasonication-Assisted Preparation of a Mn-Based Blast Furnace Slag Catalyst: Effects on the Low-Temperature Selective Catalytic Reduction Denitration Process

Novel Fe3O4@TiO2 Core–shell Nanostructure Catalyst for NO Removal Through Heterogeneous Fenton Processes

A Study on Mn-Fe Catalysts Supported on Coal Fly Ash for Low-Temperature Selective Catalytic Reduction of NOX in Flue Gas

Behavior and structure tuning of (Mn&Fe)AlOx-based catalysts for superior denitrification performance

Study on the Denitrification Performance of FexLayOz/activated Coke for NH3-SCR and the Effect of CO Escaped from Activated Coke at Mid-High Temperature on Catalytic Activity.

Optimization of A Digested Sludge-Derived Mesoporous Material As an Efficient and Stable Heterogeneous Catalyst for the Photo-Fenton Reaction

Vanadium-bearing steel slag catalysts for selective catalytic reduction of NOx by NH3