Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Study on Desulfurization and Denitration of with Industry Solid Waste by Microwave

Study on Desulfurization of with Solid Waste by Microwave

Disposal of Low Concentration Fume with Solid Waste Modified by Microwave.

Preparation the Porous Ceramic for Flue Gas Adsorption by Microwave Treatment of Industrial Waste

Application of microwave heating in disposal and utilization of MSW fly ash

The mechanism of de-SO2and De-NOx with solid waste by microwave effect

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

Effects of Microwave Modification on the Desulfurization and Denitrification of Activated Coke

Microwave-Assisted Hydrothermal Treatment with Soluble Phosphate Added for Heavy Metals Solidification in MSWI Fly Ash

Economic and Carbon Emission Analysis of Two Typical Denitrification Systems for Sintering Process in the Iron and Steel Industry

Desulfurization and Denitrification Performance of Modified Rice Husk Ash-Carbide Slag Absorbent

The Desulfurization Characteristics of Industrial Wastes During Coal Combustion

Synergetic utilization of microwave-modified fly ash and carbide slag for simultaneous desulfurization and denitrification

Research on Stabilization of MSWI Fly Ash under Microwave Function by Wet Method

New Approach to the Utilization of Microwave Thermal Energy: Desulfurization and Decarburization of Spent Catalyst Via Microwave Treatment

A New Method for Effective Utilization of Melted Solid Waste

Removal of SO2 and NOx from flue gas using mud-phosphorus slurry

Microwave roasting of blast furnace slag for carbon dioxide mineralization and energy analysis

Simultaneous Removal of SO2 and NO x Using Steel Slag Slurry Combined with Ozone Oxidation

Research on Low Emission MSW Gasification and Melting System

Integrated carbon dioxide/sludge gasification using waste heat from hot slags: syngas production and sulfur dioxide fixation.