Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

Simultaneous Desulfurization and Denitrification by Combined Ozone Oxidation and Chemical Scrubbing

Research on Simultaneous Desulfurization and Denitrification by Ozone Oxidation Integrated with Chemical Scrubber:Theoretical Analysis of SOx and NOx Absorption Properties of Limestone Slurry

Simultaneous wet desulfurization and denitration by an oxidant absorbent of NaClO2/CaO2

Simultaneous Absorption of SO2 and NO from Flue Gas with CaCO3 and Liquid Phase Oxidation

Simultaneous Removal of SO2 and NOx by Calcium-Based Sorbent with NH3 Injection at Moderate Temperatures

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

Performance and mechanism of CO2 absorption during the simultaneous removal of SO2 and NO by wet scrubbing process

Novel Method for High-Performance Simultaneous Removal of NOx and SO2 by Coupling Yellow Phosphorus Emulsion with Red Mud

Investigation on removal of noX and SO2 from flue gas by combined ozone with absorption and by-product treatment

A Superior Liquid Phase Catalyst for Enhanced Absorption of NO2 Together with SO2 after Low Temperature Ozone Oxidation for Flue Gas Treatment

Simultaneous removal of SO2 and NOx by combination of ozone oxidation and Na2S2O3solution spray

Simultaneous Absorption of SO2 and NO from Flue Gas with KMnO4/CaCO3 Slurry

Simultaneous Removal of SO2 and NO x Using Steel Slag Slurry Combined with Ozone Oxidation

Mechanism of Simultaneous Desulfurization and Denitrition for Flue Gas

Removal of NO and SO_2 from Flue Gas by Wet Scrubbing Using Aqueous NaClO Solution

Characteristics of O3 Oxidation for Simultaneous Desulfurization and Denitration with Limestone–Gypsum Wet Scrubbing: Application in a Carbon Black Drying Kiln Furnace

Simultaneous removal of SO2 and NOx from flue gas by wet scrubbing using a urea solution

Experimental Research for Multi-Pollution Control by Ozone and by-Product Purification

Synergetic utilization of microwave - assisted fly ash and carbide slag for simultaneous desulfurization and denitrification: High efficiency, low cost and catalytic mechanism

O3 oxidation combined with semi-dry method for simultaneous desulfurization and denitrification of sintering/pelletizing flue gas

Reaction mechanism of NO and SO2 Co-removal by calcium hydroxide