Abstract:This paper investigates the effect of the variation in alkoxide precursor ratio and templating agent concentration on the production of titanium silicalite (TS-1) through analysis using various physical characterisation techniques. X-ray diffraction showed clear evidence for the MFI zeolite structure and a high degree of crystallinity in all systems. For those materials prepared using a templating agent with ultra low alkali metal content, excellent agreement with previously reported unit cell parameters was obtained. For these same systems, 20% higher specific surface areas were also obtained by nitrogen adsorption. Analysis using an energy dispersive x-ray spectrometer coupled to a scanning electron microscope showed that the product typically contained between 60 and 90% of the titanium in the precursor and some dependence of titanium incorporation on the initial mixture composition was also observed. The results from Raman spectroscopy indicated titanium incorporation into the silicalite framework for all systems. For those materials produced using a templating agent with low alkali metal content, extra-framework anatase titanium dioxide was also identified at moderate Ti : Si mole ratios (>0.03) in the initial mixture. Due to its lower penetration depth, x-ray photoelectron spectroscopy (XPS) was used to characterise the titanium species in the surface layer. The XPS results indicated that a small amount of extra-framework titania was present in the surface of most of the TS-1 samples and the proportion of extra-framework material was observed to increase with both precursor alkali metal content and precursor titanium to silicon ratio.

The synthesis and characterization of titanium silicalite-1

Synthesis and characterization of titanium silicalite TS-1 prepared using phosphonium ions

Studies on the synthesis of titanium silicalite, TS-1

Synthesis of titanium silicalite-1 using amorphous SiO2 as silicon source

Preparation and Characterization of Titanium-Containing MFI from Highly Siliceous ZSM-5: Effect of Precursors Synthesized with Different Templates

Synthesis of titanium silicalite-1 (TS-1) zeolite with high content of Ti by a dry gel conversion method using amorphous TiO2–SiO2 composite with highly dispersed Ti species

The silanization process for the hydrothermal synthesis of hierarchical titanium silicalite-1

Characterization and catalytic properties of TS-1 synthesized with mixed templating reagent instead of TPAOH

Titanium species in titanium silicalite TS-1 prepared by hydrothermal method

Studies on the crystallization process of titanium silicalite-1 (TS-1) synthesized using tetrapropylammonium bromide as a template

Synthesis, characterization and catalytic performance of titanium silicalite-1 prepared in micellar media

Titanium silicalite-1 catalytic architecture: A new approach to make TS-1 applicable to industrial process

Study on the Synthesis of Clay-Based Titanium Silicalite-1 Catalytic Composite

Synthesis, characterization and catalytic performance of titanium silicalite-1 prepared in the presence of nonionic surfactants

Incorporation of Titanium into Mesoporous Silica Molecular Sieve SBA-15

Studies on the TS-1 Zeolites Synthesized by Tetrapropylammonium Bromide As Template

Synthesis of fibrous titanium silicalite (FTS-1) zeolite

Crystallization of titanium silicalite-1 (TS-1) from gels containing hexanediamine and tetrapropylammonium bromide

Synthesis of Ti-MCM-41 Using Colloidal Silica and Titanium Trichloride II. Characterization of Ti-MCM-41 Molecular Sieve

Epoxidation of Propylene with Dilute H 2 O 2 over Titanium Silicalite Containing Trace Aluminum

Ti-MCM-41 synthesized from colloidal silica and titanium trichloride: Synthesis, characterization, and catalysis