Abstract:CaMg 2 Bi 2 -based compounds, a kind of the representative compounds of Zintl phases, have uniquely inherent layered structure and hence are considered to be potential thermoelectric materials. Generally, alloying is a traditional and effective way to reduce the lattice thermal conductivity through the mass and strain field fluctuation between host and guest atoms. The cation sites have very few contributions to the band structure around the fermi level; thus, cation substitution may have negligible influence on the electric transport properties. What is more, widespread application of thermoelectric materials not only desires high Z T value but also calls for low-cost and environmentally benign constituent elements. Here, Ba substitution on cation site achieves a sharp reduction in lattice thermal conductivity through enhanced point defects scattering without the obvious sacrifice of high carrier mobility, and thus improves thermoelectric properties. Then, by combining further enhanced phonon scattering caused by isoelectronic substitution of Zn on the Mg site, an extraordinarily low lattice thermal conductivity of 0.51 W m -1 K -1 at 873 K is achieved in (Ca 0.75 Ba 0.25 ) 0.995 Na 0.005 Mg 1.95 Zn 0.05 Bi 1.98 alloy, approaching the amorphous limit. Such maintenance of high mobility and realization of ultralow lattice thermal conductivity synergistically result in broadly improvement of the quality factor β . Finally, a maximum Z T of 1.25 at 873 K and the corresponding Z T a v e up to 0.85 from 300 K to 873 K have been obtained for the same composition, meanwhile possessing temperature independent compatibility factor. To our knowledge, the current Z T a v e exceeds all the reported values in AMg 2 Bi 2 -based compounds so far. Furthermore, the low-cost and environment-friendly characteristic plus excellent thermoelectric performance also make the present Zintl phase CaMg 2 Bi 2 more competitive in practical application.

Enhanced thermoelectric performance of P-type CaMg2Bi1.98 and optimized CaAl2Si2-type Zintl phase module with equal cross-section area

Enhanced Thermoelectric Properties of P-Type CaMg2Bi2 Via a Synergistic Effect Originated from Zn and Alkali-Metal Co-doping.

Promoted application potential of p-type Mg3Sb1.5Bi0.5 for the matched thermal expansion with its n-type counterpart

Combined Tactics for Elevating the Thermoelectric Performance of CaMg2Sb2‐Based P‐type Materials

Na/Bi-co-doping and Heterogeneous Interfaces Leading to Enhanced Thermoelectric Performance of P-Type Mg3Sb2-based Zintls

Achieving High Thermoelectric Performance in Rare-Earth Element-Free CaMg 2 Bi 2 with High Carrier Mobility and Ultralow Lattice Thermal Conductivity

Transport Properties of P-Type CaMg2Bi2 Thermoelectrics

Realizing high thermoelectric performance in p-type CaZn2Sb2-alloyed Mg3Sb2-based materials via band and point defect engineering

Extraordinary Thermoelectric Performance in N-Type Manganese Doped Mg3Sb2 Zintl: High Band Degeneracy, Tuned Carrier Scattering Mechanism and Hierarchical Microstructure

Enhanced Thermoelectric Performance in SmMg<sub>2</sub>Bi<sub>2</sub> via Ca-Alloying and Ge-Doping

High thermoelectric performance and anisotropy studies of n-type Mg3Bi2-based single crystal

Higher Thermoelectric Performance of Zintl Phases (eu 0.5 Yb 0.5 ) 1−x Ca X Mg 2 Bi 2 by Band Engineering and Strain Fluctuation

High Thermoelectric Performance of CaMg2Bi2 Enabled by Dynamic Doping and Orbital Alignment

Maximizing the performance of n-type Mg 3 Bi 2 based materials for room-temperature power generation and thermoelectric cooling

Maximizing the performance of n-type Mg3Bi2 based materials for room-temperature power generation and thermoelectric cooling

Zintl Phase Yb 1– x Ba x Mg 2 Bi 1.98 Compounds with Enhanced Thermoelectric Performance Caused by Cation Substitution

Enhancing thermoelectric performance of AB 2 Sb 2 -type Zintl phase through band shaping and lattice distortion

Enhanced Thermoelectric Performance in SmMg2Bi2 Via Ca-Alloying and Ge-Doping

Improvement of the Thermoelectric Properties of P-Type Mg3Sb2 by Mg-Site Double Substitution

Enhancing the Thermoelectric Performance of n‐Type Mg3Sb2‐Based Materials via Ag Doping

High performance of Mg3Bi1.5Sb0.5 based materials for power generation: Revealing the counter-intuitive effect of tuning Bi content on the thermoelectric properties