Abstract:CaMg 2 Bi 2 -based compounds, a kind of the representative compounds of Zintl phases, have uniquely inherent layered structure and hence are considered to be potential thermoelectric materials. Generally, alloying is a traditional and effective way to reduce the lattice thermal conductivity through the mass and strain field fluctuation between host and guest atoms. The cation sites have very few contributions to the band structure around the fermi level; thus, cation substitution may have negligible influence on the electric transport properties. What is more, widespread application of thermoelectric materials not only desires high Z T value but also calls for low-cost and environmentally benign constituent elements. Here, Ba substitution on cation site achieves a sharp reduction in lattice thermal conductivity through enhanced point defects scattering without the obvious sacrifice of high carrier mobility, and thus improves thermoelectric properties. Then, by combining further enhanced phonon scattering caused by isoelectronic substitution of Zn on the Mg site, an extraordinarily low lattice thermal conductivity of 0.51 W m -1 K -1 at 873 K is achieved in (Ca 0.75 Ba 0.25 ) 0.995 Na 0.005 Mg 1.95 Zn 0.05 Bi 1.98 alloy, approaching the amorphous limit. Such maintenance of high mobility and realization of ultralow lattice thermal conductivity synergistically result in broadly improvement of the quality factor β . Finally, a maximum Z T of 1.25 at 873 K and the corresponding Z T a v e up to 0.85 from 300 K to 873 K have been obtained for the same composition, meanwhile possessing temperature independent compatibility factor. To our knowledge, the current Z T a v e exceeds all the reported values in AMg 2 Bi 2 -based compounds so far. Furthermore, the low-cost and environment-friendly characteristic plus excellent thermoelectric performance also make the present Zintl phase CaMg 2 Bi 2 more competitive in practical application.

High‐Performance CaMg2Bi2‐Based Thermoelectric Materials Driven by Lattice Softening and Orbital Alignment via Cadmium Doping

Mechanism of Thermoelectric Performance Enhancement in CaMg2Bi2‐Based Materials with Different Cation Site Doping

Enhanced Thermoelectric Properties of P-Type CaMg2Bi2 Via a Synergistic Effect Originated from Zn and Alkali-Metal Co-doping.

Mechanism of Thermoelectric Performance Enhancement in CaMg2 Bi2 -Based Materials with Different Cation Site Doping.

High Thermoelectric Performance of CaMg 2 Bi 2 Enabled by Dynamic Doping and Orbital Alignment

High Thermoelectric Performance of CaMg2Bi2 Enabled by Dynamic Doping and Orbital Alignment

Experimental Revelation of Multiband Transport in Heavily Doped BaCd2Sb2 with Promising Thermoelectric Performance

Band convergence and phonon engineering to optimize the thermoelectric performance of CaCd<sub>2</sub>Sb<sub>2</sub>

Band convergence and phonon engineering to optimize the thermoelectric performance of CaCd 2 Sb 2

Achieving High Thermoelectric Performance in Rare-Earth Element-Free CaMg 2 Bi 2 with High Carrier Mobility and Ultralow Lattice Thermal Conductivity

Transport Properties of P-Type CaMg2Bi2 Thermoelectrics

Thermoelectric Properties of Zintl Compound Ca1−xNaxMg2Bi1.98

Na/Bi-co-doping and Heterogeneous Interfaces Leading to Enhanced Thermoelectric Performance of P-Type Mg3Sb2-based Zintls

Enhanced thermoelectric performance of P-type CaMg2Bi1.98 and optimized CaAl2Si2-type Zintl phase module with equal cross-section area

Combined Tactics for Elevating the Thermoelectric Performance of CaMg2Sb2‐Based P‐type Materials

Enhancement of Thermoelectric Performance of YbMg2Bi2-based Materials by Alloying and Doping with Suppressed Bipolar Effect

Enhanced Thermoelectric Performance in N‐Type Mg3.2Sb1.5Bi0.5 by La or Ce Doping into Mg

Roles of concentration-dependent Cu doping behaviors on the thermoelectric properties of n-type Mg3Sb1.5Bi0.5

Zintl Phase Yb1–xBaxMg2Bi1.98 Compounds with Enhanced Thermoelectric Performance Caused by Cation Substitution

Electrical property enhancement and lattice thermal conductivity reduction of n-type Mg3Sb1.5Bi0.5-based Zintl compound by In&Se co-doping

Enhancing thermoelectric performance of AB 2 Sb 2 -type Zintl phase through band shaping and lattice distortion