A Low-Power, Low-EVM, SAW-Less WCDMA Transmitter Using Direct Quadrature Voltage Modulation

Xin He,Jan van Sinderen
DOI: https://doi.org/10.1109/jssc.2009.2032495
2009-12-01
Abstract:This paper describes a low-power, low EVM, SAW-less WCDMA transmitter using direct quadrature voltage modulation. The core of the modulator is a passive voltage mixer driven by 25% duty-cycle LO. In comparison with conventional approaches employing Gilbert mixers, the use of a passive voltage mixer results in significantly improved performance in terms of the output noise, linearity, LO leakage, EVM, and the power consumption in the transmitter. Delivering 4 dBm WCDMA output power at 1950 MHz, the transmitter prototype fabricated in a 45nm CMOS achieves $-{\hbox {48 dBc}}$ ACLR at 5 MHz offset, $-{\hbox {71 dBc}}$ ACLR at 10MHz offset, $-{\hbox {54 dBc}}$ LO leakage, and 1.36% EVM, while consuming only 26 mW. The measured noise floor at 4 dBm output is $-\hbox{159 dBc/Hz}$ at the frequency offset above 40 MHz, which is sufficient to safeguard the WCDMA RX band, the DCS band, and the GPS band without needing a TX SAW filter. In addition, optimized for low power consumption, over 80 dB gain control under voltage modulation is demonstrated in this paper.
engineering, electrical & electronic
What problem does this paper attempt to address?