Abstract:The sine wave test of an analog-to-digital converter (ADC) means to excite the ADC with a pure sine wave, look for the sine wave which best fits the output in least squares (LS) sense, and analyze the difference. This is described in the IEEE standards 1241–2000 and 1057–1994. Least squares is the “best” fitting method most of us can imagine, and it yields very good results indeed. Its known properties are achieved when the error (the deviation of the samples from the true sine wave) is random, white (the error samples are all independent), with zero mean Gaussian distribution. Then, the LS fit coincides with the maximum likelihood estimate of the parameters. However, in sine wave testing of ADCs, these assumptions are far from being true. The quantization error is partly deterministic, and the sample values are strongly interdependent. For sine waves covering less than, say, 20 quantum levels, this makes the sine wave fit worse than expected, and since small changes in the sine wave affect the residuals significantly, especially close to the peaks, ADC error analysis may become misleading. Processing of the residuals [e.g., the calculation of the effective number of bits, (ENOB)] can exhibit serious errors. This paper describes this phenomenon, analyzes its consequences, and suggests modified processing of samples and residuals to reduce the errors to negligible level.

Determining ADC effective number of bits via histogram testing

Accurate Exponential Histogram Test Method for ADC Linearity Test

A Novel Linear Histogram BIST for ADC

A Novel Histogram Test for Estimating Integral Nonlinearity Errors of Analog-to-Digital Converters

Effective ADC linearity testing using sinewaves

New Dynamic Test Methods for Determination of Nonlinearity and Effective Resolution of A/D Converters

Improved Determination of the Best Fitting Sine Wave in ADC Testing

Testing and optimizing ADC performance: a probabilistic approach

ADC Testing With Verification

ADC Parameter Test Based on Improved Maximum Likelihood Estimation

A critical note to IEEE 1057-94 standard on hysteretic ADC dynamic testing

Low cost high accuracy method for testing A/D dynamic parameters

Full information ADC test procedures using sinusoidal excitation, implemented in MATLAB and LabVIEW

Research on Analog-to-Digital Converter (ADC) Dynamic Parameter Method Based on the Sinusoidal Test Signal

Acceleration of the ADC Test With Sine-Wave Fit

Study on the Choice of Sampling Rate in Dynamic Testing of ADC

Low-cost test approach to the static parameters of A/D converter

Windows for ADC dynamic testing via frequency-domain analysis

Dynamic testing and diagnostics of A/D converters