Abstract:Dynamic testing of high-resolution Sigma-Delta $(\Delta\Sigma)$ Analog-to-Digital converters (ADCs) is extremely challenging and expensive since it requires the use of spectrally pure stimulus with at least 10dB better signal-to-noise ratio (SNR) and total harmonic distortion (THD) than the ADC under test. This paper presents a low cost model parameter estimation based test and diagnosis methodology for the dynamic specifications of high-precision $\Delta\Sigma$ ADCs using a multi-tone test input. In the proposed test methodology, the response of a behavioral model of the ADC incorporating its key module level non-idealities is matched with the response of the ADC under test by solving a nonlinear optimization problem that finds the best non-ideality parameters corresponding to the observed DUT test response. The dynamic specifications of the ADC are then calculated from the derived model parameters. The multi-tone test stimulus is designed in such a way as to maximize the accuracy with which the model non-ideality parameters can be calculated from the observed test response using a genetic test stimulus optimization algorithm. For test response analysis, the digital pulse sequence at the output of the sigma-delta modulator is made externally observable and utilized as a test access point. A key contribution is that the dynamic specifications such as ENOB, SNR, and THD of the converter as well as module level non-idealities contributing to those specifications can be simultaneously determined from the derived model parameters. The test method is fast and diagnosis is very accurate. Simulation results indicate the validity of the proposed methodology.

A critical note to IEEE 1057-94 standard on hysteretic ADC dynamic testing

Optimization Of Sample/Hold Circuit For High-Speed And High-Resolution Adcs

A Low Power Sample-and-Hold Circuit for Pipelined A/D Converter

Effective ADC linearity testing using sinewaves

Experimental Comparison of Different Standards for Dynamic Characterization of ADCs

Improved Static Testing of A/D Converters for DC Measurements

Development of radiation tolerance evaluation and measurement system for spaceborne D/A converter

Testing and optimizing ADC performance: a probabilistic approach

Determining ADC effective number of bits via histogram testing

An 18-Bit 2MSPS SAR ADC with Double Passive Noise-Shaping Calibration

Full information ADC test procedures using sinusoidal excitation, implemented in MATLAB and LabVIEW

Windows for ADC dynamic testing via frequency-domain analysis

Signature Testing and Diagnosis of High Precision S? ADC Dynamic Specifications Using Model Parameter Estimation

Evaluation of ADC Testing Systems Using ADC Transfer Standard

Improved Determination of the Best Fitting Sine Wave in ADC Testing

ADC Dynamic Parameter Testing Scheme Under Relaxed Conditions

Testing development for ADC on automatic test system

ADC Testing With Verification

High-Precision ADC Testing with Relaxed Reference Voltage Stationarity.

Improving Source-Follower Buffer For High-Speed Adc Testing

Decreasing the Sensitivity of ADC Test Parameters by Means of Wobbling