Abstract:Highly porous and hydrophobic silica aerogel is fabricated using fly ash and trona ore as the starting materials and the cost-effective ambient pressure drying technique. The optimal calcination parameters are determined as temperature of 850°C, holding time of 2h, and the trona ore/fly ash mass ratio of 1.4. The CO2 release mechanism during calcination is proposed and has been verified by the Thermogravimetric and Differential Scanning Calorimetry analysis (TG/DSC) and X-ray fluorescence (XRF) technique. The hydrogel is derived from reacting the calcination mixture with sulphuric acid solution, followed by filtration. The impurities can be effectively removed through water washing and solvent exchange processes. No ion exchange resin is used in this preparation method, and thus it is a safe, inexpensive and much more straightforward process. In order to minimize drying shrinkage, the hydrogel is first transformed into an alcogel by soaking in ethanol, after which the alcogel is surface modified with the hexane/ethanol/trimethylchlorosilane (hexane/ethanol/TMCS) mixture solution. It has been observed that the specific surface area, BJH desorption pore volume, and BJH desorption average pore diameter all first increase and then decrease so that reach to the maximum values once the heat treatment temperature approaches 500°C due to the oxidation of CH3 groups on the silica skeleton surface. The final product presents special characteristics including: (1) high thermal stability for maintaining hydrophobicity up to 476°C, (2) contact angle of the as-dried silica aerogel as high as 151°, (3) silica particle size of ca. 3–6nm, agreeing well with the model as reported, (4) and the 500°C heat treated sample possessing a large specific surface area of 856.2m2/g, a large pore volume of 2.92cm3/g, and a BJH desorption average pore diameter of 17.1nm. The proposed inexpensive approach produces silica aerogel with superior properties and is a scalable-manufacturing method for large-scale industrial production.

Synthesis and Surface Strengthening Modification of Silica Aerogel from Fly Ash

Atmospheric Drying Preparation and Microstructure Characterization of Fly Ash Aerogel Thermal Insulation Material with Superhydrophobic

Effect of surface modification on physical properties of silica aerogels derived from fly ash acid sludge

Study on preparation and surface modification of precipitated silica obtained from fly ash

Synthesis of high specific surface area silica aerogel from rice husk ash via ambient pressure drying

Synthesis and Characterization of Silica Aerogel and Its Composite Materials

Microstructural and physical properties of silica aerogels based on oil shale ash

Nanoporous Silica–Chitosan Aerogels for Thermal Insulation and Flame Retardancy

Preparation of Silica Aerogels Via Non-supercritical Drying and Their Formation Process

Energy effective utilization of circulating fluidized bed fly ash to prepare silicon-aluminum composite aerogel and gypsum

Preparation and Surface Modification Mechanism of Silica Aerogels Via Ambient Pressure Drying

Preparation of Silica Aerogel from Oil Shale Ash by Fluidized Bed Drying

Rapid Synthesis of Super Insulation Silica Aerogel Composites Strengthened with Mullite Fibers

Ambient-Dried Silica Aerogel Powders Derived from Coal Gangue by Using One-Pot Method

Study on Silica Aerogel Modified by Trimethylchlorosilane

A novel low-cost method of silica aerogel fabrication using fly ash and trona ore with ambient pressure drying technique

Recycling Coal Fly Ash for Super-Thermal-Insulating Aerogel Fiber Preparation with Simultaneous Al2O3 Extraction

Recycling Coal Fly Ash for Super-Thermal-Insulating Aerogel Fiber Preparation with Simultaneous Al<sub>2</sub>O<sub>3</sub> Extraction

Silica aerogels formed from soluble silicates and methyl trimethoxysilane (MTMS) using CO2 gas as a gelation agent

Effect of the Tmcs/Hydrogel Volume Ratio on Physical Properties of Silica Aerogels Based on Fly Ash Acid Sludge

Preparation of Precipitated Nano-silica from Acid Leaching Residue of Coal Ash by Carbonation Method