Abstract:How to deal with the brittleness of ceramic materials is always one of the hot topics in the field of materials science. Design of layered ceramics with textured structure is one of the effective methods to improve their fracture toughness. The introduction of additives as interlayer phases can balance fracture toughness and flexural strength. However, the research about addition of interlayer phases and their mechanisms in the layered ceramics is still limited. In this work, nacre-like alumina ceramics were successfully fabricated by freeze casting followed by hot pressing. Silicon nitride was incorporated as the interlayer phase, and the effect on the mechanical properties of the nacre-like alumina was investigated. The addition of silicon nitride was beneficial to improvement of interlayer bonding between the alumina layers due to formation of sialon phase, leading to increase of flexural strength but decease of fracture toughness. When the content of silicon nitride was 3.3 wt%, flexural strength and fracture toughness of the sample was 468 MPa and 6.2 MPa m1/2, respectively. Compared with the sample without silicon nitride, the flexural strength was enhanced significantly. Additionally, both flexural strength and fracture toughness were improved as compared the sample without any additives. This work can provide available references for design and fabrication of high-strength and high-toughness ceramics by properly tuning the layer structure and interlayer phase composition.

Design of crack deflection induced high toughness laminated Si3N4 ceramics based on hollow oriented one-dimensional microstructure

New Route to Improve the Fracture Toughness and Flexural Strength of Si3N4 Ceramics by Adding FeSi2

Optimization of Microstructure to Improve Si3n4 Ceramics with Thermal Conductivity and Mechanical Properties: Effect of Si and Α-Si3n4 Powder Composition

Reinforcement mechanisms and optimum design of laminated ceramic composites

High toughness and R-curve behaviour of laminated SiC/graphite ceramics

Toughness and R-curve behaviour of laminated Si3N4/SiCw ceramics

Mechanical properties and microstructure of a Si3N4/Ti3SiC2 multilayer composite

A facile preparation of multi-scale BN/SiC ceramic with high toughness by vacuum-assisted filtration

A NUMERICAL SIMULATION AND EXPERIMENTAL STUDY ON TOUGHENING DESIGN OF MULTILAYER CERAMIC

Mechanical properties and microstructure of laminated Si3N4+SiCw/BN+Al2O3 ceramics densified by spark plasma sintering

Biomimetic high toughness Si3N4 ceramics with inverse-bouligand structure

Biomimetic structure design — a possible approach to change the brittleness of ceramics in nature

Biomimetic Structure Design, Preparation Process and Mechanical Properties of Multiphase Ceramics with High Toughness

Fabrication and mechanical properties of nacre-like alumina with addition of silicon nitride

Control of Composition and Structure in Laminated Silicon Nitride/Boron Nitride Composites

Effects of additives to Si3N4 matrix on microstructure and properties of laminated Si3N4/BN ceramics

Microstructure and fracture toughness of SiAlCN ceramics toughened by SiCw or GNPs

Microstructure and Properties of Porous Si3n4 Ceramics with A Dense Surface

Efficient multiscale strategy for toughening HfB 2 ceramics: A heterogeneous ceramic–metal layered architecture

Si3N4 Hollow Microsphere Toughened Porous Ceramics from Direct Coagulation Method Via Dispersant Reaction

A MECHANICS ANALYSIS OF STRENGTHENING-TOUGHENING DESIGN OF MULTILAYER STRUCTURE CERAMICS