Abstract:A strain-insensitive temperature sensor based on multimode interference using standard multimode fibers (MMFs) is proposed according to the comprehensive study of the characteristics of the MMFs. The temperature and strain dependences on the core diameter, numerical aperture (NA), and the length of the MMF section in the single-mode--multimode--single-mode (SMS) fiber structure are investigated experimentally. The results indicate that the larger core diameter of the MMF leads to higher temperature sensitivity but lower strain sensitivity (absolute values); the higher NA does not influence the temperature sensitivity but results in higher absolute value of strain sensitivity; the longer MMF section brings lower temperature sensitivity but does not have an impact on strain sensitivity. These findings also contribute to the theoretical analysis of the length dependence in the SMS fiber sensors. Besides, the results of the characterization study show that the strain sensitivity is relatively low, which brings a possibility to develop a strain-insensitive temperature sensor. The proposed sensor is used for temperature sensing while the strain is constantly applied from 0 to 1100 $\mu\epsilon$ with steps of 100 $\mu\epsilon$. The measured results are consistent with the comprehensive study. The mean temperature sensitivity is 6.14 pm/$^{\circ}$C with a standard deviation of 0.39 pm/$^{\circ}$C, which proves that the proposed temperature sensor exhibits good stability and is insensitive to strain. We expect that these results will provide a profound guideline to fiber sensors based on multimode interference.

Speckle-decoded temperature-insensitive strain identification in a multimode optical fiber

Strain Sensor Based on Gourd-Shaped Single-Mode-multimode-single-mode Hybrid Optical Fibre Structure.

Fiber-optic multimode interference sensing: comprehensive characterization and its potential for strain-insensitive temperature sensing

Optical Fiber Strain and Temperature Sensor Based on an In-Line Mach–Zehnder Interferometer Using Thin-Core Fiber

Fiber-Optic Point-Based Sensor Using Specklegram Measurement

Temperature and Strain Sensor Based on a Few-Mode Photonic Crystal Fiber

Temperature and strain simultaneous sensing measurement based on an all-fiber Mach-Zehnder interferometer and fiber Bragg grating

Optical Fiber Sensor for Temperature and Strain Measurement Based on Multimode Interference and Square-Core Fiber

Research of Simultaneous Measurement of Temperature and Strain of Fiber Optic Cable Material

Multi-parameters SMS optical fiber sensing by employing SCBSS signal processing technique

High Precision Temperature Insensitive Strain Sensor Based on Fiber-Optic Delay

Experimental Research on an Optical Fiber Temperature and Stress Sensor Based on the Time Offset

A Spiral-Polished Fiber Sensor for Strain and Temperature Measurement

Advanced Fiber Optic Sensing for Cryogenic Simultaneous Temperature and Strain Measurement

Strain-insensitive temperature sensing with a dual polarization fiber grating laser

Temperature Insensitive Distributed Wide-dynamic-range Strain Sensing based on Polarization-Maintaining Photonic Crystal Fiber

High-Resolution and Large-Dynamic Range Fiber-Optic Sensors Based on Dual-Mode Direct Spectrum Interrogation Method

Bending-Loss-Resistant Distributed Temperature and Strain Discriminative Brillouin Sensor Based on 98 mol% Germania-Doped Few-Mode Fiber

Simultaneous displacement, temperature and strain sensing system based on fiber macro-bend loss and edge filter

Interferometric Fiber Optic Surface Plasmon Resonance Sensor for Temperature and Strain Measurement

Simultaneous measurement of temperature and strain: cross-sensitivity considerations