Abstract:A strain-insensitive temperature sensor based on multimode interference using standard multimode fibers (MMFs) is proposed according to the comprehensive study of the characteristics of the MMFs. The temperature and strain dependences on the core diameter, numerical aperture (NA), and the length of the MMF section in the single-mode--multimode--single-mode (SMS) fiber structure are investigated experimentally. The results indicate that the larger core diameter of the MMF leads to higher temperature sensitivity but lower strain sensitivity (absolute values); the higher NA does not influence the temperature sensitivity but results in higher absolute value of strain sensitivity; the longer MMF section brings lower temperature sensitivity but does not have an impact on strain sensitivity. These findings also contribute to the theoretical analysis of the length dependence in the SMS fiber sensors. Besides, the results of the characterization study show that the strain sensitivity is relatively low, which brings a possibility to develop a strain-insensitive temperature sensor. The proposed sensor is used for temperature sensing while the strain is constantly applied from 0 to 1100 $\mu\epsilon$ with steps of 100 $\mu\epsilon$. The measured results are consistent with the comprehensive study. The mean temperature sensitivity is 6.14 pm/$^{\circ}$C with a standard deviation of 0.39 pm/$^{\circ}$C, which proves that the proposed temperature sensor exhibits good stability and is insensitive to strain. We expect that these results will provide a profound guideline to fiber sensors based on multimode interference.

Simultaneous measurement of temperature and strain: cross-sensitivity considerations

Simultaneous Measurement of Displacement and Temperature Based on Two Cascaded Balloon-Like Bent Fibre Structures

Simultaneous Measurement of Displacement and Temperature Based on a Balloon-Shaped Bent SMF Structure Incorporating an LPG

Advanced Fiber Optic Sensing for Cryogenic Simultaneous Temperature and Strain Measurement

Research On Measurement Of Fiber Bragg Grating Considering The Cross-Sensitivity Of Temperature And Strain

Simultaneous Measurement of Temperature and Strain Based on Fiber Loop Mirror Combined with Fiber Bragg Grating

Temperature and strain simultaneous sensing measurement based on an all-fiber Mach-Zehnder interferometer and fiber Bragg grating

Simultaneous Measurement of Strain (to 2000 /spl Mu//spl Epsiv/) and Temperature (to 600/spl Deg/c) Using a Combined Sb-Er-Ge-codoped Fiber-Fluorescence and Grating-Based Technique

Simultaneous Independent Temperature and Strain Measurement Using One Fiber Bragg Grating Based on the Etching Technique

Research of Simultaneous Measurement of Temperature and Strain of Fiber Optic Cable Material

Compact Fiber Sensor With High Spatial Resolution for Simultaneous Strain and Temperature Measurement

Hybrid Interferometer Sensor Based on the Enhanced Vernier Effect for the Simultaneous Measurement of Strain and Temperature

Simultaneous Strain and Temperature Measurement Using Compact Core-Offset Inter-Modal Interferometer with Embedded Fiber Bragg Grating

Simultaneous Measurement of Strain and Temperature Distributions Using Optical Fibers with Different GeO2 and B2O3 Doping

Temperature compensation high strain measure ment based on a Fabry-Perot interferometer with the virtual-assisted Vernier effect

Fiber-optic multimode interference sensing: comprehensive characterization and its potential for strain-insensitive temperature sensing

Temperature and Strain Sensor Based on a Few-Mode Photonic Crystal Fiber

Cross Sensitivity of Brillouin Scattering Distributed Fiber Sensor

Experimental study on a parallel optical fiber Sagnac loops-based sensor with the advantages of both high sensitivity and ultra-wide measurement range

Simultaneous Measurement of Pressure and Temperature Using a Single Fiber Bragg Grating

Simultaneous strain and temperature measurement by cascading few-mode fiber and single-mode fiber long-period fiber gratings