Abstract:The applicability of chemical actinometry to characterize the fluence in UV reactors with reflections, non-parallel light, and variable water transmittance is limited due to the unknown effective path length or hydraulic shortcuts within the reactor. In this study, the effects of reflection and transmittance on actinometry were examined and a new, optimized and easy method for determining fluence was developed. KI/KIO3 and uridine actinometry experiments were carried out under controlled conditions using a collimated beam apparatus and a completely mixed batch reactor with or without diffuse reflection and compared to biodosimetry results. Whereas optically opaque actinometers such as KI/KIO3 are not directly capable of predicting the fluence of reflecting reactors, the results of uridine actinometry are influenced by reflection and transmission. To precisely predict the fluence rate in UV reactors with uridine, knowledge about the effective optical path length of the light is needed. Here, an existing method to mathematically calculate the optical path length was adopted and optimized for uridine actinometry. Results for average fluence were validated by biodosimetry using MS2 phages under different degrees of reflection and transmission. It could be shown that by modifying the bottom of the reactor with diffusely reflecting polytetrafluoroethylene foil, the fluence rate was increased by a factor of approximately 2.6 and the path length by factor of 2.4. When only half of the bottom was covered with reflective foil, fluence rate increased by a factor of 1.8 and path length by 1.8. Although this new approach cannot replace biodosimetry, to predict the fluence distribution received by microorganisms, it can provide means to characterize more complex reactor designs, validate results of advanced reactor modeling, and quantify fluence for non-parallel irradiation and reflective light, especially for the application of high fluence (e.g., advanced oxidation processes), where biodosimetry may be too sensitive. Further, comparing the fluence obtained with actinometry to the results of biodosimetry might qualitatively indicate hydraulic short cuts or unideal fluence distributions for flow-through reactors.

The method to measure the UV emittance of low-pressure-lamps: a commentary on

Numerical Verification for a New Type of UV Disinfection Reactor

Etendue analysis and measurement of light source with elliptical reflector.

A review of the fluence determination methods for UV reactors: Ensuring the reliability of UV disinfection

Keitz Method for Measuring of 254 Nm Radiant Flux in Low Pressure Mercury Lamps

Optical Testing and Evaluating System for Optical Radiation Safety for Ophthalmic Instruments

Automatic Measurement for Light Distribution Curve of Ultra High Pressure Mercury Lamps

Microdischarge Process and Vacuum Ultraviolet Emission Properties of Dielectric-Barrier-Discharge-Type Flat Fluorescent Lamps

Improved Method for Real-Time Fluence Monitoring in UV Reactors

Comparison of theoretical computation and bioassays of UV intensity distribution in an ultraviolet disinfection reactor

Experimental Assessment of Photon Fluence Rate Distributions in a Medium-Pressure UV Photoreactor.

Estimating the Fluence Delivery in UV Disinfection Reactors Using a ‘Detector-Model’ Combination Method

Impact of Inner-Wall Reflection on UV Reactor Performance As Evaluated by Using Computational Fluid Dynamics: the Role of Diffuse Reflection.

Measurement and Calculation of Ultraviolet Radiation in Disinfection and Environmental Purification

Revealing photon transmission in an ultraviolet reactor: Advanced approaches for measuring fluence rate distribution in water for model validation

Development of Monitored Tunable Biodosimetry for Fluence Validation in an Ultraviolet Disinfection Reactor

Comparison of Low- and Medium-Pressure Ultraviolet Lamps: Photoreactivation of Escherichia Coli and Total Coliforms in Secondary Effluents of Municipal Wastewater Treatment Plants

Two Dimensional Keitz Method for the Radiant Power Measurement of Planar Ultraviolet Excilamps

An actinometric method to characterize performance of reflecting UVC reactors used for water treatment

Effects of Distance, Temperature, and Relative Humidity on the Irradiance of Ultraviolet‐C Germicidal Lamp: A Quantitative Study

185 nm radiation measurement of high output low pressure mercury lamps