Abstract:The applicability of chemical actinometry to characterize the fluence in UV reactors with reflections, non-parallel light, and variable water transmittance is limited due to the unknown effective path length or hydraulic shortcuts within the reactor. In this study, the effects of reflection and transmittance on actinometry were examined and a new, optimized and easy method for determining fluence was developed. KI/KIO3 and uridine actinometry experiments were carried out under controlled conditions using a collimated beam apparatus and a completely mixed batch reactor with or without diffuse reflection and compared to biodosimetry results. Whereas optically opaque actinometers such as KI/KIO3 are not directly capable of predicting the fluence of reflecting reactors, the results of uridine actinometry are influenced by reflection and transmission. To precisely predict the fluence rate in UV reactors with uridine, knowledge about the effective optical path length of the light is needed. Here, an existing method to mathematically calculate the optical path length was adopted and optimized for uridine actinometry. Results for average fluence were validated by biodosimetry using MS2 phages under different degrees of reflection and transmission. It could be shown that by modifying the bottom of the reactor with diffusely reflecting polytetrafluoroethylene foil, the fluence rate was increased by a factor of approximately 2.6 and the path length by factor of 2.4. When only half of the bottom was covered with reflective foil, fluence rate increased by a factor of 1.8 and path length by 1.8. Although this new approach cannot replace biodosimetry, to predict the fluence distribution received by microorganisms, it can provide means to characterize more complex reactor designs, validate results of advanced reactor modeling, and quantify fluence for non-parallel irradiation and reflective light, especially for the application of high fluence (e.g., advanced oxidation processes), where biodosimetry may be too sensitive. Further, comparing the fluence obtained with actinometry to the results of biodosimetry might qualitatively indicate hydraulic short cuts or unideal fluence distributions for flow-through reactors.

Comparison of theoretical computation and bioassays of UV intensity distribution in an ultraviolet disinfection reactor

Numerical Verification for a New Type of UV Disinfection Reactor

Bacterial inactivation effect of UV in aquaculture recirculating water

A review of the fluence determination methods for UV reactors: Ensuring the reliability of UV disinfection

Development of Monitored Tunable Biodosimetry for Fluence Validation in an Ultraviolet Disinfection Reactor

Revealing photon transmission in an ultraviolet reactor: Advanced approaches for measuring fluence rate distribution in water for model validation

Estimating the Fluence Delivery in UV Disinfection Reactors Using a ‘Detector-Model’ Combination Method

Effect of UV-C LED arrangement on the sterilization of Escherichia coli in planar water disinfection reactors

Comparison of Low- and Medium-Pressure Ultraviolet Lamps: Photoreactivation of Escherichia Coli and Total Coliforms in Secondary Effluents of Municipal Wastewater Treatment Plants

An actinometric method to characterize performance of reflecting UVC reactors used for water treatment

Efficiency improvement of a flow-through water disinfection reactor using UV-C light emitting diodes

Improved Method for Real-Time Fluence Monitoring in UV Reactors

The inactivation effect of ultraviolet disinfection reactor on the high concentration of bacteriophage MS2

Measurement and Calculation of Ultraviolet Radiation in Disinfection and Environmental Purification

Study on the Inactivation Effect and Damage on Bacteria of Ultraviolet Light with Multi Irradiance by UV-LED

Experimental Assessment of Photon Fluence Rate Distributions in a Medium-Pressure UV Photoreactor.

A pilot-scale study on ultraviolet disinfection system for drinking water

Comparison of radiant intensity in aqueous media using experimental and numerical simulation techniques

Investigation of baffle configurations on the water disinfection efficiency using ultraviolet C light-emitting diodes

Numerical Simulation of a UV-PCO Plate Reactor

Experimental study on the effect of light source arrangements on the disinfection performance of upper-room 222 nm Far-UVC