Abstract:Diamond has great potential applications in high-power, high-frequency semiconductor devices because of its wide band gap (5.5 eV), high thermal conductivity (22W/(cm·K)), and high carrier mobility (4500 cm2/(V·s) for electron, and 3800 cm2/(V·s) for hole). It has been widely considered as an ultimate semiconductor. From the analysis of our previous work, we find that the output current of field effect transistor based on hydrogen-terminated polycrystalline diamond is usually larger than that based on single crystal diamond, and that the preferential orientations of the polycrystalline diamond are mainly \begin{document}$ \langle 110\rangle $\end{document} and \begin{document}$ \langle 111\rangle $\end{document} shown by XRD results. Therefore, in order to further analyze the effect of surface orientation on the device performance of hydrogen-terminated diamond field effect transistor (FET), we study the devices fabricated respectively on the (110) plane and (111) plane single crystal diamond plates obtained from a single 3.5-mm-thick single crystal diamond grown by the microwave plasma chemical vapor deposition on the high-pressure high-temperature synthesized diamond substrate. Prior to processing the device, these diamond plates are characterized by atomic force microscope, Raman spectra and photoluminescence (PL) spectra. The results of Raman and PL spectra show that (110) plane and (111) plane plates originating from the same CVD single crystal diamond have no significant difference in optical property. Then the normally-on hydrogen-terminated diamond FET with a gate length of 6 μm is achieved. The device on (111) plane delivers a saturation drain current of 80.41 mA/mm at a gate voltage VGS = –4 V, which is approximately 1.4 times that of the device on (110) plane. Meanwhile, the on-resistance of the device on (111) plane is 48.51 Ω·mm, and it is only 67% of the device on (110) plane. Analyses of the capacitance-voltage show that the hole concentration of the gated device on (110) plane and (111) plane are 1.34 × 1013 cm–2 and 1.45 × 1013 cm–2, respectively, approximately at the same level. In addition, the hole density of the device on both (110) and (111) plane increase near-linearly with the increase of gate voltage from the threshold voltage to – 4 V, indicating that the control effect of the gate on the carrier in the channel is uniform. The possible reason for the higher saturation drain current as well as the lower on-resistance of the device on (111) plane is that its sheet resistance is lower.

Topological Mott transistor with high current density based on hydrogen-terminated diamond

High mobility top gated field-effect transistors and integrated circuits based on chemical vapor deposition-derived monolayer MoS 2

High-Mobility p-Channel Wide Bandgap Transistors Based on h-BN/Diamond Heterostructures

High-mobility p-channel wide-bandgap transistors based on hydrogen-terminated diamond/hexagonal boron nitride heterostructures

High On-State Current P-Type Tunnel Effect Transistor Based on Doping Modulation

Characteristics of H-terminated Single Crystalline Diamond Field Effect Transistors

1 W/mm Output Power Density for H-Terminated Diamond MOSFETs with Al2O3/SiO2 Bi-Layer Passivation at 2 GHz

Preparation of High Conductivity Hydrogenated Silicon-Doped Diamond and MOSFET

High Performance of Normally‐On and Normally‐Off Devices with Highly Boron‐Doped Source and Drain on H‐Terminated Polycrystalline Diamond

RF Performance of Hydrogenated Single Crystal Diamond MOSFETs

Diamond electronics with high carrier mobilities

High mobility hydrogen-terminated diamond FET with h-BN gate dielectric using pickup method

Vertical-type two-dimensional hole gas diamond metal oxide semiconductor field-effect transistors

Transport Properties of the Two-Dimensional Hole Gas for H-Terminated Diamond with an Al<sub>2</sub>O<sub>3</sub> Passivation Layer

An enhanced two-dimensional hole gas (2DHG) C-H diamond with positive surface charge model for advanced normally-off MOSFET devices

Extreme Enhancement-Mode Operation Accumulation Channel Hydrogen-Terminated Diamond FETs with $V_{th} < -6V$ and High On-Current

A Field Effect Transistor Using Highly Nitrogen-Doped CVD Diamond for Power Device Applications

High Performance Single Crystalline Diamond Normally-Off Field Effect Transistors

High performance ionic-liquid-gated air doped diamond field-effect transistors

On‐Chip Integrated High Gain Complementary MoS2 Inverter Circuit with Exceptional High Hole Current P‐Channel Field‐Effect Transistors (adv. Electron. Mater. 10/2022)

Characteristics of Hydrogen-Terminated Single Crystalline Diamond Field Effect Transistors with Different Surface Orientations