Abstract:Gadolinium-silica (Gd-silica) gels were prepared via sol–gel route combined to γ-irradiation (0–30 kGy), starting from Tetra-Ethyl-Orthosilicate (Si(OCH 2 CH 3 ) 4 , TEOS) and gadolinium nitrate Gd(NO 3 ).6H 2 O used as raw materials. The phase transformation and morphology of the gels derived from both precursors were characterized by XRD and TEM analysis. Differential scanning calorimetry (DSC) under non-isothermal conditions was used to determine the crystallization activation energy ( E c ) at different γ-doses (0, 8, 15, 25 and 30 kGy), using the methods suggested by Kissinger, Moynihan and Ozawa. XRD analysis of the samples calcined up to 1100°C for 2 h reveals the formation of gadolinium silicate (Gd 4.67 (SiO 4 ) 3 O) apatite crystalline phase with the presence of small traces of gadolinium pyrosilicate (Gd 2 Si 2 O 7 ), the average particle sizes about 50 nm. TEM observations show spherical Gd-silicate nanoparticles homogeneously dispersed in silica matrix, the mean diameter size is about 40 nm. From DSC analysis, it was observed that the onset crystallization temperature ( T x ) and peak crystallization temperature ( T c ) both increase with increasing γ-dose. According to Kissinger, Moynihan and Ozawa models, the crystallization activation energies for Gd-silicate phase formation were found to be 465.2, 474.5 and 465.7 kJ mol −1 , respectively for unirradiated samples and 429.1, 447 and 438 kJ mol −1 when the γ-irradiation reaches 30 kGy respectively. Results revealed that the values of E c decreased when the γ-dose increases and attains the minimum value at the dose of 15 kGy and then increase at higher doses. The crystallization rate factor (K) was also seen to decrease with increasing of γ-dose. Gamma irradiation increases the crystallization peak temperature ( T c ). The crystallization activation energy ( E c ) estimated from the three models is in good agreement and much well with those reported for silicate systems. Gamma irradiation decreases the E c and crystallization rate factor (K). These preliminary results can provide useful technical information for a better understanding and control of the crystallization process of this type of nanomaterial.

Characteristic Investigations on Bio-Silica Gel Prepared from Teff (Eragrostis tef) Straw: Effect of Calcination Time

Preparation of Methyltrimethoxysilane Derived Silica Aerogel Films via Ambient Pressure Drying

New Insights Into Method Development and Characterization of Amorphous Silica From Wheat Straw

Effect of Temperature and Method of Synthesis on Morphology and Phase Transition of Amorphous and Crystalline Nano Silica Extracted from Mission Grass (Pennisetum Polystachion)

Calcining Silica Gels at Different Drying Stages

Synthesis of high specific surface area silica aerogel from rice husk ash via ambient pressure drying

Silica aerogels formed from soluble silicates and methyl trimethoxysilane (MTMS) using CO2 gas as a gelation agent

Effects of Surfactants on the Synthesis of Silica Aerogels Prepared by Ambient Pressure Drying

Preparation of silica aerogel from rice hull ash by drying at atmospheric pressure

Structural and Morphological Properties of Silica Extracted from Wild Oat Straw: Effect of Post-Thermal Treatment

Influence of Calcining Temperature on the Fractal Dimension of Silica Xerogel

Preparation and Characterization of New Sol-Gel Hybrid Inulin-TEOS Adsorbent

Effect of different trimethyl silylating agents on the hydrophobic and physical properties of silica aerogels

MECHANOCHEMICAL METHOD OF PROCESSING SILICA-CONTAINING PLANT MATTER

Synthesis of Al2O3-SiO2 aerogels with low thermal conductivity and high strength by methyltriethoxysilane as a silica precursor

Preparation of silica xerogel with high silanol content from sodium silicate and its application as CO2 adsorbent

Influence of Calcination Procedure on Porosity and Surface Fractal Dimensions of Silica Xerogels Prepared under Different Evaporation Conditions

Synthesis of sodium silicate-based hydrophilic silica aerogel beads with superior properties: Effect of heat-treatment

Synthesis of Silica Xerogel from Geothermal Sludge by Ultrasonic Assisted Alkali Extraction-Acid Precipitation

Characterization of Multimodal Silicas Using TG/DTG/DTA, Q-TG, and DSC Methods

Thermal behavior of gadolinium-silica gels prepared via sol–gel route combined to γ-irradiation process