Abstract:Swing arc narrow gap GMA welding experiments were carried out with a Box–Behnken response surface design. Weld metal and heat-affected sizes were measured from the joints obtained, and an ANOVA was performed to obtain well-fitting models for definition of the heat-affected length. Overlapping patterns and microstructures were analyzed and observed in zones within the heat-affected length through the thickness direction. In addition, thermal processes in typical zones of HAZs were calculated by FEM and analyzed to explain the patterns in the typical coarse grain heat-affected zones (CG-HAZs) with thermal simulated microstructures attached. It was realized that a single pass could only be confused with an austenitized process by two passes. The coarse grain heat-affected zone of a single pass could be divided into an unaltered coarse grain heat-affected zone (UACG-HAZ), a supercritically reheated coarse grain heat-affected zone (SCRCG-HAZ) and an intercritically reheated heat-affected zone (IRCG-HAZ). It is likely that there would be an intercritically reheated UACG-HAZ upon the UACG-HAZ. The microstructures in the CG-HAZs and the UACG-HAZ were mainly lath bainite and a little acicular ferrite; the microstructures in the SCRCG-HAZ were short lath bainite, granular bainite and acicular ferrite and the microstructures in the IRCG-HAZ were massive textures and secondary austenite decomposition products. The cooling times in the typical bainite transformation procedures were similar to one another in a secondary austenitized process and significantly longer than those in a single austenitized thermal cycle, which caused similar patterns in reheated CG-HAZs and an increase in acicular ferrite compared to CG-HAZs. The prior austenite grain sizes caused differences among the reheated CG-HAZs.

Microstructure and Low-Temperature Toughness of Reheated Coarse-Grained Heat-Affected Zone of 06Ni9DR Steel

DSI-based Studies of the Effects of High-temperature Aging on Local Mechanical Properties of HR3C/T92 Dissimilar Steel Welded Joint

Study on Microstructure and Low‐Temperature Impact Toughness in Coarse Grain Heat‐Affected Zone of EH460 Steel

Effect of Heat Input on Microstructure and Properties in Heat Affected Zone of Astm A572 Gr.65 Steel

Factors Influencing Notch Toughness of Coarse-grained Heat Affected Zone for 9% Ni Steel

Simulated Coarse Grain Heat‐Affected Zone Transformation Behavior of Newly Developed Zr–Ti–RE Deoxidized High‐Strength Low‐Alloy Steels with Extremely High Impact Toughness

Effect of Initial Microstructure on the Toughness of Coarse-Grained Heat-Affected Zone in a Microalloyed Steel

Influence of Microstructure Evolution on Reheat Cracking Behavior of T23 Steel Weld Joint

Inter-Critically Reheated CGHAZ of Ultra-High-Strength Martensitic Steel with Different Cooling Rates

Significant influence of heat input on microstructure evolution and mechanical properties of the simulated CGHAZ in a 1000 MPa grade ultra-high strength steel

Microstructure and Mechanical Properties of Simulated Unaltered Coarse Grained Heat Affected Zones of 10crni3mov Steel by Double-Sided Double Arc Welding

Effect of Microstructure on Impact Toughness and Fatigue Performance in Coarse-Grained Heat-Affected Zone of Bainitic Steel Welds

Mechanism of Interfacial Microstructure Evolution of G115 Steel in Simulated Heat Affected Zone

Improvement of impact toughness by microstructure refinement of simulated CGHAZ through enhancing welding heat input of low carbon Mo-V-Ti-N-B steel

Toughness of Heat-Affected Zone of 800 Mpa Grade Low Alloy Steel

Study on Local Brittle Zone Phenomena of Intercritically Reheated Coarse-Grained Heat-Affected Zone in Pipeline Steels

Effect of Heat Input on Austenite Reversion, Recrystallization, and Ensuing Impact Toughness in Simulated Intercritical Coarse‐Grained Heat Affected Zone of Medium Mn Steel

Effect of Welding Processes with High Heat Input on the Microstructure and Toughness of Coarse-Grained Heat-Affected Zone of a High-Strength High-Toughness Steel

Effect of welding heat input on microstructure and impact toughness in CGHAZ of X100Q steel

Overlapping Features and Microstructures of Coarse Grain Heat-Affected Zones in Swing Arc Narrow Gap GMA Welded EH40 Grade Steels

Elucidating the heat input on CGHAZ microstructure and its irregular effect on impact toughness for a novel V-N microalloying weathering steel