Mixture of Si 3 N 4 powder and SiO 2 sand as novel DC arc quenching medium for improvement of current limiting performance of model electric fuse

Naoto Kodama,Y Yokomizu,Waku TAKENAKA

DOI: https://doi.org/10.1088/1361-6463/ad2ab2

2024-02-20

Journal of Physics D Applied Physics

Abstract:A current limiting and consequent DC arc interruption requires an arc resistance r arc rising for DC fuse. The flattery silica(SiO 2 )-sand has been used as an arc quenching medium in fuse over decades. However, it is less reported about a novel arc quenching medium which enable more r arc rising compared to the flattery silica-sand. This paper uniquely selected novel arc quenching medium based on following material properties: (1) an electrical resistivity and a thermal conductivity in solid-phase, (2) a possibility of r arc rising in gas-phase, (3) possibility of the electrical insulation after re-solidification, and (4) cost of materials. As a result, we originally selected powder mixture of silicone-nitride(Si 3 N 4 ) and the flattery silica-sand as a promising novel arc quenching medium. Therefore, DC interruption experiments were performed using Si 3 N 4 /flattery silica-sand powder mixture under different Si 3 N 4 concentration condition. As a result of 1000 A DC arc quenching experiment, utilization of Si 3 N 4 powder with the flattery silica-sand successfully increased the arc resistance r arc during the arc quenching process. The increasing Si 3 N 4 concentration exhibited further increase in r arc during the arc quenching process. As a result of r arc rise, the arc quenching time was significantly shortened to 30 ms for 30wt.%Si 3 N 4 condition from 55 ms for the silica-sand condition. In addition, utilization of Si 3 N 4 powder achieved high insulation resistance over few MΩ after the DC arc interruption. The above results clearly indicate that utilization of Si 3 N 4 powder with the flattery silica-sand can increase the DC interruption performance of the fuse.

physics, applied