Abstract:The characterization of silicon carbide (SiC) by specific electrical atomic force microscopy (AFM) modes is highly appreciated for revealing its structure and properties at a nanoscale. However, during the conductive AFM (C-AFM) measurements, the strong electric field that builds up around and below the AFM conductive tip in ambient atmosphere may lead to a direct anodic oxidation of the SiC surface due to the formation of a water nanomeniscus. In this paper, the underlying effects of the anodization are experimentally investigated for SiC multilayers with different doping levels by studying gradual SiC epitaxial-doped layers with nitrogen (N) from 5 × 1017 to 1019 at/cm3. The presence of the water nanomeniscus is probed by the AFM and analyzed with the force-distance curve when a negative bias is applied to the AFM tip. From the water meniscus breakup distance measured without and with polarization, the water meniscus volume is increased by a factor of three under polarization. AFM experimental results are supported by electrostatic modeling to study oxide growth. By taking into account the presence of the water nanomeniscus, the surface oxide layer and the SiC doping level, a 2D-axisymmetric finite element model is developed to calculate the electric field distribution nearby the tip contact and the current distributions at the nanocontact. The results demonstrate that the anodization occurred for the conductive regime in which the current depends strongly to the doping; its threshold value is 7 × 1018 at/cm3 for anodization. Finally, the characterization of a classical planar SiC-MOSFET by C-AFM is examined. Results reveal the local oxidation mechanism of the SiC material at the surface of the MOSFET structure. AFM topographies after successive C-AFM measurements show that the local oxide created by anodization is located on both sides of the MOS channel; these areas are the locations of the highly n-type-doped zones. A selective wet chemical etching confirms that the oxide induced by local anodic oxidation is a SiOCH layer.

Structure and corrosion resistance of SiC thin film coated on NdFeB by magnetron sputtering

Corrosion Protection of Nd-Fe-B Sintered Magnets by Aluminum Coating

Anti-corrosion performance of Si-surface-alloying NdFeB magnets obtained with magnetron sputtering and thermal diffusion

Fabrication of Lanthanum-Silane Film by Electrochemically Assisted Sol–gel Method for Enhanced Corrosion Resistance of Sintered NdFeB

Influence of radio frequency magnetron sputtering parameters on the structure and performance of SiC films

The corrosion resistance mechanisms of the cr-coated SiC in molten Na2SO4 salt: Strengthened boundaries and protective scales

Corrosion Behavior of Sintered NdFeB Magnets Coated with Ni Coatings Deposited by Ion Beam Sputtering

CORROSION BEHAVIOR OF THE Ni-SiC NANOCOMPOSITE COATINGS

Study on superhydrophobicity and excellent corrosion resistance of a novel Ni‐SiC nanocomposite coating

Microstructure, Mechanical and Tribological Properties of CrSiC Coatings Sliding Against SiC and Al2O3 Balls in Water

Effect of SiC doping on corrosion behavior of Cf/Mg composites

A design of sintered Nd-Fe-B magnet exhibiting superior corrosion resistance based on the metallurgical behavior of Ni and Cr

Fabrication and Anti-Corrosion Performance of Superhydrophobic Silane Film on Sintered NdFeB

Electrodeposited FeCoNiWMo high entropy alloy/SiC nanocomposite coatings: Microstructure, mechanical properties and corrosion resistance

Microstructure, mechanical and high-temperature tribological properties of amorphous SiC films by pulsed magnetron sputtering

Electrodeposition and Characterization of Nano-Structured Ni–SiC Composite Films

Influence of SiC content in B4C–nSiC composites corrosion in molten FLiNaK salt at 800°C

Performance of Ni–SiC composites deposited using magnetic-field-assisted electrodeposition under different magnetic-field directions

Impact of Magnetic Field Direction on Performance and Structure of Ni-Co-SiC Coatings Fabricated via Magnetic-Field-Induced Electrodeposition

Improved antioxidative and mechanical properties of SiC coated C/C composites via a SiO2-SiC reticulated layer

SiC Doping Impact during Conducting AFM under Ambient Atmosphere