Abstract:Ceramic coatings with aluminum titanuate (Al2TiO5) were prepared on Ti–6Al–4V alloy using pulsed bi-polar Micro-arc Oxidation (MAO). The micromorphology and phase composition of the micro-arc-oxidition ceramic coatings on the titanium alloy were characterized by X-ray powder diffraction (XRD), and scanning electron microscopy (SEM) respectively. The results revealed that the distinct discharge channels and pores on the surface of the micro-arc-oxidition coatings appeared, and these channels were connected in the molten state. The electrolyte concentration was inversely proportional to the coating hardness; additionally, the coating prepared with sodium aluminate and sodium hypophosphite concentrations of 4 g/L and 0.5 g/L, respectively, was the most refined after high-temperature sintering, and it was demonstrated to better prevent oxidation. Increasing the electrolyte concentration coincided with fluctuating coating thermal shock resistance. The thermal shock resistance of the coating respectively prepared with sodium aluminate, and the sodium hypophosphite concentrations of 4 g/L and 0.5 g/L was the highest. Additionally, the high-concentration coatings performed significantly better than the low-concentration coatings. The oxidation resistance of the coating samples was also significantly higher than that of the TC4 titanium alloy substrate. The adhesion strength between the coatings and the substrate with and without the sealing treatment was measured by tensile tests. Then, the high-temperature oxidation performance of the coating samples with and without the sealing treatment was investigated by conducting a high-temperature oxidation experiment at a calcinating temperature of 500 °C. The results indicate that the adhesion strength between the coatings and substrate was high for the as-prepared and sealed micro-arc oxidation samples regardless of whether they were calcined. The high-temperature oxidation mass increase curves for the sealed and unsealed coating samples calcined at 500 °C for 500 h revealed that the high-temperature-oxidation-induced mass increase of the coating samples sealed with a sodium silicate solution was much lower than that of the titanium alloy substrate. Thus, the sealing treatment significantly improved the high-temperature oxidation resistance of the TC4 titanium alloy. Lastly, the high-temperature oxidation behavior at 500 °C was analyzed and discussed.

High-temperature oxidation behavior of Ti2AlNb alloy with PEO/hBN composite coating at 1000 °C

Thermal Oxidation Behaviour of Ti6Al7Nb and Ti6Al4V Alloys

Influence factors of high temperature oxidation for Pt-modified-aluminide bond coatings

Different Growth Mechanisms of Alumina on the Surface of NiPtAl and MCrAlY Bondcoatings in EB-PVD TBC System

Fabrication of High Temperature Oxidation Resistance Nanocomposite Coatings on PEO Treated TC21 Alloy

High Temperature Oxidation Behaviors of BaO/TiO2 Binary Oxide-Enhanced NiAl-Based Composites

Microstructural evolution and high-temperature oxidation mechanisms of a titanium aluminide based alloy

The oxidation behaviors of TiB1.73, Al0.59Ti0.41N, and TiB1.73/Al0.59Ti0.41N coatings deposited by high-power impulse magnetron sputtering method

High Temperature Oxidation Behaviors of Al/Cr Composite Coating on Ti2AlNb Alloy

Structural and High-Temperature Oxidation Performance of Al-Co-Y Co-deposited Coatings on a TiAl-Nb Alloy at Low Temperatures

Oxidation characteristics of gamma-TiAl-8Nb coated with a CrAlYN/CrN nanoscale multilayer coating

Comprehensive study on the microstructure evolution and oxidation resistance performance of NiCoCrAlYTa coating during isothermal oxidation at High temperature

Improving the high temperature oxidation resistance of TiAl alloy by SiOC coating

High-temperature oxidation resistance of ceramic coatings on titanium alloy by micro-arc oxidation in aluminate solution

High-Temperature Oxidation of NbTi-Bearing Refractory Medium- and High-Entropy Alloys

Microstructure and High Temperature Properties of Nb2O5/TiO2 Coatings by Micro-arc Oxidation

Microstructure Analysis of Initial Alumina of Pt-Modified Aluminide Coatings on Ni-Based Alloy

On the high temperature oxidation behavior of AlCrBN/TiAlNbSiN multilayer coatings with addition of boron and silicon

High-Temperature Oxidation Resistance of High-Nb TiAl-Based Alloy

High-temperature performance of Pt-modified Ni-20Co-28Cr-10Al-0.5Y coating: Formation mechanism of Pt-rich overlayer and its effect on thermally grown oxide failure

A novel approach to coating for improving the comprehensive high-temperature service performance of TiAl alloys