Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Prediction of Critical Heat Flux in Tube Bundles With Crossflow

A General Correlation for Heat Transfer During Saturated Boiling with Flow Across Tube Bundles

Correlations for Saturated Critical Heat Flux in Microchannels

Heat Transfer Correlations for Single-Phase Flow, Condensation, and Boiling in Microfin Tubes

COMPARISON ANALYSIS OF CHF PARAMETRIC TRENDS IN VERTICAL TUBE AND 5 x 5 BUNDLE

The Study of Critical Heat Flux in Upflow Boiling Vertical Round Tube under High Pressure

Prediction of Critical Heat Flux for Subcooled Flow Boiling in Annulus and Transient Surface Temperature Change at CHF

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

A Mechanistic Bubble Crowding Model for Predicting Critical Heat Flux in Subchannels of a Bundle

Universal Critical Heat Flux (CHF) Correlations for Cryogenic Flow Boiling in Uniformly Heated Tubes

Prediction of Critical Heat Flux in Non-Uniform Heated Rod Bundle Based on Modified CHF Empirical Correlations

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Prediction of Critical Heat Flux in Rod Bundle Based on CFD Methodology

On the Critical Heat Flux Assessment of Micro- and Nanoscale Roughened Surfaces

Assessment of two-phase heat transfer coefficient and critical heat flux correlations for cryogenic flow boiling in pipe heating experiments

Critical Heat Flux Prediction Model for Low Quality Flow Boiling of Water in Vertical Circular Tube

Experimental Study on Critical Heat Flux in Bilaterally Heated Narrow Annuli

Numerical analysis on flow and heat transfer of a tube bundle in a horizontal-tube falling film evaporator

Prediction of Critical Heat Flux (CHF) for the High-Pressure Region in Uniformly Heated Vertical Round Tubes

Experimental Study of the Local and Average Falling Film Evaporation Coefficients in a Horizontal Enhanced Tube Bundle Using R134a

Evaluation of Prediction Methods for Heat Transfer Coefficient of Annular Flow and a Novel Correlation