Experimental Study on Single- to Two-Phase Flow and Heat Transfer of Water in a Small Tube
Guangwei Hong,Fanyu Qu,Shenghui Liu,Jiaying Gao,Yihang Wu,Hanxing Liu,Feixiang Yuan,Ruiying Gao,Liangyong Chen,Xiaoliang Zhu,Yanping Huang
DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2024.125472
IF: 5.2
2024-01-01
International Journal of Heat and Mass Transfer
Abstract:Experimental investigation on flow boiling heat transfer in a small tube under high system pressure has been conducted in this study. The test-section is constructed with a 316L stainless steel tube. The inner diameter and heated length of the test-section are 5 mm and 930 mm, respectively. The working fluid is deionized water. The operating conditions of the experiments are as follows, the mass flux from 548 to 978 kg/(m2·s), the wall heat flux from 136 to 238 kW/m2, and the system pressure from 1.0 to 2.9 MPa. The experimental results showed that the inlet subcooling mainly affects the onset of nucleate boiling, but its impact on the heat transfer coefficient at the same vapor quality is almost negligible. The heat transfer coefficient increases with the increase of mass flux and wall heat flux, especially in the region where xe < 0.02. The average heat transfer coefficient is higher under high system pressure owing to the variation of the thermophysical properties. Additionally, the existing flow and heat transfer correlations cannot predict the flow boiling heat transfer coefficient and frictional pressure drop in the experiments accurately enough. Therefore, the new flow and heat transfer correlations are developed based on the experimental data in this paper, and the mean absolute deviation of the flow boiling heat transfer correlation and frictional pressure drop correlation are 13.3% and 12.1%, respectively.