Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

Peripheral heat transfer prediction of the subcooled falling liquid film on a horizontal smooth tube

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Experimental study on the distribution of local heat transfer coefficient of falling film heat transfer outside horizontal tube

Heat Transfer Correlations for Single-Phase Flow, Condensation, and Boiling in Microfin Tubes

Study of Heat Transfer for Co2 Flow Boiling in Horizontal Small Diameter Tubes

Experimental research on falling film flow and heat transfer characteristics outside the vertical tube

A New Correlation For Subcooled Flow Boiling Heat Transfer In A Vertical Narrow Microchannel

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Modelling of evaporative falling-film heat transfer over a horizontal tube

Predictions of Heat Transfer Coefficients and Pressure Drops to Supercritical Pressure Hcfc22 Flowing in A Small Tube

Numerical analysis on flow and heat transfer of a tube bundle in a horizontal-tube falling film evaporator

Two-phase Heat Transfer Correlations in Three-Dimensional Hierarchical Tube

Numerical Study on Flow Heat Transfer Characteristics of Horizontal Tube Falling-Film Evaporator

Heat Transfer Correlations For Condensation In Three-Dimentional Surface Enhanced Heat Transfer Tubes

A prediction model based on data-driven method for velocity and heat transfer coefficient of falling-film liquid on horizontal tube

Heat Transfer Characteristics of Falling Film Evaporation on Horizontal Tube Arrays

Prediction of Critical Heat Flux in Tube Bundles With Crossflow

A New Heat Transfer Correlation for Supercritical Fluids

A General Correlation for Saturated Two-Phase Flow Boiling Heat Transfer Inside Horizontal and Vertical Tubes

Single Phase And Two Phase Flow Characteristics And Heat Transfer In Micro-Fin Tubes

A correlation of heat transfer for falling film evaporation on the horizontal tube with multiple-precision expansion method