Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

A New Heat Transfer Model for Flow Boiling of Refrigerants in Micro-Fin Tubes

Boiling Heat Transfer Correlations for Refrigerant Mixtures Flowing Inside Micro-Fin Tubes

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Heat Transfer Correlations for Single-Phase Flow, Condensation, and Boiling in Microfin Tubes

Frictional Pressure Drop During Flow Boiling in Micro-Fin Tubes: A New General Correlation

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Evaluation of Frictional Pressure Drop Correlations During Flow Boiling of Refrigerants in Micro-Fin Tubes

Study on Flow Boiling of Refrigerants in Micro/Mini-Channels

Two-Phase Flow Heat Transfer In Micro-Fin Tubes

Experimental Study of Boiling Heat Transfer in Smooth/micro-Fin Tubes of Four Refrigerants

Experimental Investigation of Evaporation Heat Transfer Inside Horizontal Micro-Fin Tubes

Saturated/subcooled Flow Boiling Heat Transfer Inside Micro/mini-Channels: A New Prediction Correlation and Experiment Evaluation

Prediction of evaporation heat transfer coefficient based on gas–liquid two-phase annular flow regime in horizontal microfin tubes

Numerical Gas-Liquid Stratified Flow Regime Model On Evaporation Heat Transfer In Horizontal Microfin Tubes

A New General Correlation for Frictional Pressure Drop During Condensation Inside Horizontal Micro-Fin Tubes

Prediction of Friction Factor and Heat Transfer Coefficient for Single-Phase Forced Convection Inside Microfin Tubes

A General Correlation for Saturated Two-Phase Flow Boiling Heat Transfer Inside Horizontal and Vertical Tubes

The Correlations of Heat Transfer of Refrigerant-Oil Mixture Flow Boiling Inside Small Smooth Tubes

Numerical Model of a Microchannel Parallel Flow Evaporator with New Flow Boiling Heat Transfer Correlation

THEORETICAL MODEL OF EVAPORATION HEAT TRANSFER BASED ON GAS-LIQUID ANNULAR FLOW OF HORIZONTAL MICROFIN TUBE

A Modified Correlative Model for Condensation Heat Transfer in Horizontal Enhanced Tubes with R32 and R410A Refrigerants