Abstract:An accurate and acceptable correlation for the prediction of two-phase pressure drop is considered a crucial step in heat exchanger design. Although many existing models and correlations were developed and proposed in the past, their ability to predict within acceptable error bands when applied in general to flow boiling flows is limited, even within their originally recorded ranges. The discrepancies are worse when predicting two-phase pressure drop in small to micro-scale passages. Therefore, the aim of the work described in this paper is to assess the most well-known models and correlations using a large experimental data-bank. The data-bank includes four refrigerants, namely R134a, R245fa, HFE-7100 and HFE-7200, small to micro heat exchangers made of different metals and different channel configurations. In addition, the data cover a large range of operating conditions, which can allow generally applicability of new correlations developed. This range covers channel hydraulic diameter of 0.46−4.26 mm, heated length of 20−500 mm, system pressure of 1 − 14 bar, mass flux of 50−700 kg/m 2 s, wall heat flux ranging from 2 to 234 kW/m 2 and exit vapour quality up to one. Twenty six existing models and correlations that were developed and proposed for vertical/horizontal flow, single/multi-channels and circular/non-circular channels were evaluated. Moreover, the effect of using different equations for calculating the two-phase mixture viscosity, void fraction, Fanning friction factor and Lockhart–Martinelli parameter was assessed and discussed. The mean absolute error of the existing correlations when compared with our data-bank was more than 30 %. Therefore, a new correlation for calculating the two-phase multiplier, which was strongly dependent on the Boiling number and the Lockhart–Martinelli parameter, was developed and then the frictional component and total two-phase pressure drop relationships were completed.

Evaluation of Frictional Pressure Drop Correlations During Flow Boiling of Refrigerants in Micro-Fin Tubes

Frictional Pressure Drop During Flow Boiling in Micro-Fin Tubes: A New General Correlation

A New General Correlation for Frictional Pressure Drop During Condensation Inside Horizontal Micro-Fin Tubes

Study on Flow Boiling Heat Transfer Characteristics of R161/oil Mixture Inside Horizontal Micro-Fin Tube

Evaluation of Existing Frictional Pressure Drop Correlations During Condensation of R410A in Four Horizontal Tubes

New Generalized Flow Boiling Heat Transfer and Frictional Pressure Drop Correlations for R32

Correlations of Two-phase Friction of Refrigerant in Horizontal Smooth Tube with 2.5 mm inside Diameter

A New Heat Transfer Model for Flow Boiling of Refrigerants in Micro-Fin Tubes

Development of a correlation for pressure drop of two-phase flow inside horizontal small diameter smooth and microfin tubes

Flow boiling pressure drop correlation in small to micro passages

A GENERAL CORRELATION FOR FRICTIONAL PRESSURE DROP OF FLOW BOILING IN PLATE HEAT EXCHANGERS

Evaluation of prediction models on frictional pressure drop for condensation flow in horizontal circular tubes

Experimental Investigation and Correlation of Two-Phase Frictional Pressure Drop of R410A–oil Mixture Flow Boiling in a 5 Mm Microfin Tube

New flow boiling frictional pressure drop multipliers for smooth and microfin tubes

Evaluation of Two-Phase Frictional Pressure Drop Correlations Against Experimental Data

A GENERAL FRICTIONAL PRESSURE DROP CORRELATION FOR CONDENSATION IN MICROFIN TUBES

Heat Transfer Correlations for Single-Phase Flow, Condensation, and Boiling in Microfin Tubes

Measurement and correlation of frictional pressure drop of R-410A/oil mixture flow boiling in a 7 mm straight smooth tube

Boiling Heat Transfer Correlations for Refrigerant Mixtures Flowing Inside Micro-Fin Tubes

Measurement and Correlation of Frictional Pressure Drop of Refrigerant-Based Nanofluid Flow Boiling Inside a Horizontal Smooth Tube

R410A flow boiling in horizontal annular channels of enhanced tubes, part I: Pressure drop