Abstract:For the past few years, research in the field of flow boiling heat transfer has gained immense popularity for unravelling the dominant mechanism responsible for controlling heat transfer and identifying a parametric trend for understanding the characteristics of flow boiling heat transfer. This has led to several assumptions and models for predicting heat transfer during flow boiling without any known generalized mechanism. This study therefore seeks to experimentally study the characteristics of heat transfer during flow boiling over a wide range but small increase in vapor quality from a single-phase subcooled region through to a two-phase superheated vapor region. The study was performed with an R134a refrigerant in a single horizontal circular stainless-steel smooth tube that had an internal diameter of 5 mm. In this experimental study, local heat transfer coefficients and frictional pressure drop were measured for low heat fluxes of 4.6–8.5 kW/m2, mass fluxes of 200–300 kg/(m2s), vapor quality from −0.1 to 1.2 and a low constant saturation pressure of 460 kPa. Flow patterns observed during the study were recorded with a high-speed camera at 2000 fps. In covering a wide range of vapor quality, a peak of heat transfer coefficient near a vapor quality of zero and a local minimum observed in the low vapor quality region were observed, and both were sensitive to heat flux and mildly sensitive to mass flux. Generally, at low vapor quality, the heat transfer coefficient deteriorated with vapor quality and this was sensitive to heat flux but insensitive to mass flux and vapor quality, indicating nucleate boiling dominance in low vapor quality regions. In high vapor quality regions, the heat transfer coefficient was sensitive to mass flux and insensitive to heat flux. This indicates the dominance of convective boiling. In the low vapor quality regions, the flow patterns observed were slug and intermittent, while in the high vapor quality region, annular and mist flow patterns were observed. Generally, frictional pressure drop increased with increasing mass flux and vapor quality in the two-phase region.

Pressure Drop and Heat Transfer of Flow Boiling R134a in a Dimpled Flat Duct

Experimental Study on Forced Convection Hydraulic and Thermal Characteristics in a Dimpled Flat Duct

Comparison of Flow Boiling Pressure Drop and Heat Transfer of R134a with Low GWP Alternative R1234ze(E) in a Dimpled Flat Duct

Convective Boiling Heat Transfer and Pressure Drop Characteristics of R134a in a Microfinned Helically Coiled Tube

Experimental Study on Evaporative Heat Transfer and Pressure Drop of R-134a in a Horizontal Dimpled Tube

Experimental Study of Horizontal Flow Boiling Heat Transfer Coefficient and Pressure Drop of R134a from Subcooled Liquid Region to Superheated Vapor Region

R410A flow boiling in horizontal annular channels of enhanced tubes, part I: Pressure drop

Flow Boiling in Dimpled Plate Heat Exchangers with Different Geometric Parameters: Analysis of Asymmetric Channels

Flow Boiling Heat Transfer of R134a in a Horizontal Smooth Tube: Experimental Results, Flow Patterns, and Assessment of Correlations

FLOW BOILING HEAT TRANSFER AND TWO-PHASE PRESSURE DROP OF R134A IN A MICROFINNED HELICALLY COILED TUBE

Pressure Drop Characteristics of R134a During Flow Boiling in a Single Rectangular Micro-Channel

An Experimental Study of Flow Pattern and Pressure Drop for Flow Boiling Inside Microfinned Helically Coiled Tube

Condensation Heat Transfer in Smooth and Three-Dimensional Dimpled Tubes of Various Materials

Pressure Drop of R134a and R1234ze(E) Flow Boiling in Microchannel Arrays with Single- and Double-Side Heating

Flow Boiling Heat Transfer of R134a in a Vertical Helically Coiled Tube

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Investigation of Flow Boiling in Micro-Channels: Heat Transfer, Pressure Drop and Evaluation of Existing Correlations

Numerical Investigation on Condensation Heat Transfer and Pressure Drop Characteristics of R134a in Horizontal Flattened Tubes

Numerical investigation of flow boiling characteristics of R134A in a smooth horizontal tube

Heat Transfer of R134a in a Horizontal Internally Ribbed Tube and in a Smooth Tube under Super Critical Pressure

Pressure drop of R134a in mini channels with micro pin fins during flow boiling