Abstract:For the past few years, research in the field of flow boiling heat transfer has gained immense popularity for unravelling the dominant mechanism responsible for controlling heat transfer and identifying a parametric trend for understanding the characteristics of flow boiling heat transfer. This has led to several assumptions and models for predicting heat transfer during flow boiling without any known generalized mechanism. This study therefore seeks to experimentally study the characteristics of heat transfer during flow boiling over a wide range but small increase in vapor quality from a single-phase subcooled region through to a two-phase superheated vapor region. The study was performed with an R134a refrigerant in a single horizontal circular stainless-steel smooth tube that had an internal diameter of 5 mm. In this experimental study, local heat transfer coefficients and frictional pressure drop were measured for low heat fluxes of 4.6–8.5 kW/m2, mass fluxes of 200–300 kg/(m2s), vapor quality from −0.1 to 1.2 and a low constant saturation pressure of 460 kPa. Flow patterns observed during the study were recorded with a high-speed camera at 2000 fps. In covering a wide range of vapor quality, a peak of heat transfer coefficient near a vapor quality of zero and a local minimum observed in the low vapor quality region were observed, and both were sensitive to heat flux and mildly sensitive to mass flux. Generally, at low vapor quality, the heat transfer coefficient deteriorated with vapor quality and this was sensitive to heat flux but insensitive to mass flux and vapor quality, indicating nucleate boiling dominance in low vapor quality regions. In high vapor quality regions, the heat transfer coefficient was sensitive to mass flux and insensitive to heat flux. This indicates the dominance of convective boiling. In the low vapor quality regions, the flow patterns observed were slug and intermittent, while in the high vapor quality region, annular and mist flow patterns were observed. Generally, frictional pressure drop increased with increasing mass flux and vapor quality in the two-phase region.

Experimental analysis of pressure drops and heat transfer coefficient during upward two-phase flow of R-134a/R-245fa mixture in an offset-strip finned passage

Pressure Drop and Heat Transfer of Flow Boiling R134a in a Dimpled Flat Duct

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

Study on Flow Boiling Heat Transfer Characteristics of R161/oil Mixture Inside Horizontal Micro-Fin Tube

Theoretical and Experimental Analyses of Two-Phase Flow Condensation Heat Transfer Inside the Horizontal Micro-Fin Tube

Numerical investigation of flow boiling characteristics of R134A in a smooth horizontal tube

Flow Boiling Heat Transfer of R134a in a Horizontal Smooth Tube: Experimental Results, Flow Patterns, and Assessment of Correlations

Experimental Study of Horizontal Flow Boiling Heat Transfer Coefficient and Pressure Drop of R134a from Subcooled Liquid Region to Superheated Vapor Region

Flow Boiling Heat Transfer Characteristic of Refrigerant R1234ze(E) in Horizontal Circular Tube

An experimental study on two-phase flow patterns and heat transfer characteristics during boiling of R134a flowing through a multi-microchannel heat sink

Flow boiling heat transfer characteristics and correlation development of R290/R600a mixtures in an internally threaded tube{fr}Caractéristiques de transfert de chaleur par ébullition en écoulement et développement de corrélations pour les mélanges R290/R600a dans un tube fileté interne

A numerical study of condensation heat transfer and pressure drop in horizontal round and flattened minichannels

An experimental investigation of R245fa flow boiling heat transfer performance in horizontal and vertical tubes

Experimental study on spray cooling heat transfer performance of R245fa/R142b mixture in boiling regime

Pressure Drop of R134a and R1234ze(E) Flow Boiling in Microchannel Arrays with Single- and Double-Side Heating

Experimental investigation on flow boiling heat transfer of R290, R600a and their mixtures in a horizontal minichannel

Macro-to-microchannel transition in two-phase flow: Part 2 – Flow boiling heat transfer and critical heat flux

Experiment on Boiling Heat Transfer of Refrigerant R134a in Mini-channels

R410A flow boiling in horizontal annular channels of enhanced tubes, part I: Pressure drop

An experimental study of annular film flow condensation in a micro-fin tube with high mass flux

Pressure drop of R134a in mini channels with micro pin fins during flow boiling