Abstract:Aiming for the application of refrigerant two-phase cooling on battery thermal management, this study presented an experimental investigation on the flow boiling characteristics of R1233zd(E) in a parallel mini-channel heat sink, which consisted of 21 channels with the length of 140 mm and the cross section of 1.5 x 1.5 mm(2). Under the saturation pressure of 125 kPa, the boiling curve of R1233zd(E) and the heat transfer coefficient were analyzed under different heat fluxes (5-100 kW/m(2)), mass fluxes (150-600 kg/m(2) s) and inlet subcoolings (2.5-8 K). In addition, the flow pattern was captured using high-speed camera. The results showed that the onset of nucleate boiling was delayed with the increase of refrigerant mass flux and inlet subcooling, while the transition of heat transfer was verified by flow pattern visualization. The measured wall superheat was compared with present correlations, showing that the predicted value was always smaller than the experimental results. Flow boiling on local points showed that the nucleate boiling was triggered later at the channel located at the center axis of the heat sink, meanwhile the approach of critical heat flux was more obvious at channel outlet. Due to the graduate transition of flow boiling mechanism, refrigerant mass flux had limited influence on the local heat transfer coefficient when the heat flux was lower than 30 kW/m(2), while enhancement on heat transfer could be observed with larger mass flux when the heat flux exceeded 30 kW/m(2). The local experimental data of heat transfer coefficient were compared with 6 correlations from the literatures. It was found that the best prediction was presented by Liu and Winterton model with a MAE of 23.4%, while Kim and Mudawar model showed best agreement under different mass fluxes. A simple modification was conducted on Kim and Mudawar model, and the calibrated model presented a better prediction accuracy with the MAE of 17.6% and 83.2% of total data within the error of +/- 30%. (C) 2021 Elsevier Ltd. All rights reserved.

Pressure Drop of R134a and R1234ze(E) Flow Boiling in Microchannel Arrays with Single- and Double-Side Heating

Pressure Drop and Heat Transfer of Flow Boiling R134a in a Dimpled Flat Duct

Comparison of Flow Boiling Pressure Drop and Heat Transfer of R134a with Low GWP Alternative R1234ze(E) in a Dimpled Flat Duct

Visualization of R1233zd(E) Flow Boiling in Parallel Mini-channels

Saturated Flow Boiling Heat Transfer of R1233zd(E) in Parallel Mini-Channels: Experimental Study and Flow-Pattern-based Prediction

Experimental Investigation on Flow Boiling Instability of R1233zd(E) in a Parallel Mini-Channel Heat Sink for the Application of Battery Thermal Management

Experimental Investigation on Flow Boiling Heat Transfer and Pressure Drop of a Low-GWP Refrigerant R1234ze(E) in a Horizontal Minichannel

Pressure drop of R134a in mini channels with micro pin fins during flow boiling

Flow Boiling Heat Transfer Characteristic of Refrigerant R1234ze(E) in Horizontal Circular Tube

Investigation of Flow Boiling in Micro-Channels: Heat Transfer, Pressure Drop and Evaluation of Existing Correlations

R410A flow boiling in horizontal annular channels of enhanced tubes, part I: Pressure drop

Critical heat flux, heat transfer and pressure drop at high mass fluxes for R123 in a single microchannel

Flow Pattern Study and Pressure Drop Prediction of Two-Phase Boiling Process in Different Surface Wettability Microchannel

Pressure drop of R134a and R1234ze(E) during condensation in horizontal microchannel arrays cooled symmetrically and asymmetrically

Experimental study on flow boiling of refrigerant R1233zd(E) in microchannels: Heat transfer

Experiment on Boiling Heat Transfer of Refrigerant R134a in Mini-channels

An Experimental Investigation of Pressure Drop in Two-Phase Flow during the Condensation of R410A within Parallel Microchannels

Experimental study on flow boiling characteristics of R134a inside high-heat-flux microchannels

Frictional Pressure Drop During Flow Boiling in Micro-Fin Tubes: A New General Correlation

Flow boiling frictional pressure drop inside micro/mini-channels: A new general model and experimental investigation

Evaluation of Frictional Pressure Drop Correlations During Flow Boiling of Refrigerants in Micro-Fin Tubes