Critical heat flux, heat transfer and pressure drop at high mass fluxes for R123 in a single microchannel

Thalles Coimbra Borba Roldão,Cristiano Bigonha Tibiriçá

DOI: https://doi.org/10.1016/j.ijheatmasstransfer.2023.125143

IF: 5.2

2024-01-10

International Journal of Heat and Mass Transfer

Abstract:This paper presents new experimental data on pressure drop, heat transfer coefficient, and critical heat flux during flow boiling of low-pressure fluid R123 in microchannels. High mass velocities were used, above the values found in the literature in tests with this fluid. Experiments were conducted in a single smooth and horizontal microchannel, with an internal diameter of 1.1 mm and heating sections of 46 and 100 mm. The mass velocities used were between 1500 and 7500 kg/m 2 s. Saturation temperature ranged from 40.1 to 85.1 o C. The outlet vapor quality varied between -0.54 and 0.53 for the CHF results, between 0 and 0.5 for the pressure drop results, and between 0 and 0.35 for the HTC results, respectively. Record critical heat flux values for flow boiling of R123 in smooth microchannels were achieved, reaching 1.44 MW/m 2 . An analysis was made of the influence of an upstream pressure drop in avoiding instabilities during critical heat flux experiments. The highest heat transfer coefficient values during convective boiling of R123 in smooth microchannels were also obtained, with values close to 43.3 kW/m 2 K. The saturation temperatures used were among the highest for flow boiling of R123 in smooth microchannels found in the literature. Correlations for frictional pressure drop, heat transfer coefficient, and critical heat flux were evaluated in predicting the experimental data. An analysis was made on the influence of the void fraction correlation when estimating both the accelerational and frictional pressure drop.

engineering, mechanical,thermodynamics,mechanics