Experimental study on flow boiling characteristics of R134a inside high-heat-flux microchannels
Zhiqiang Zhang,Li Jia,Chao Dang,Yi Ding
DOI: https://doi.org/10.1016/j.ijheatfluidflow.2024.109372
IF: 2.643
2024-04-11
International Journal of Heat and Fluid Flow
Abstract:Flow boiling in parallel microchannels is an efficient method to deal with the high heat flux removal challenge for electronic modules. In this work, the visualized experiments on the R134a flow boiling inside a high-heat-flux microchannels heat sink were performed. The heat sink contains 27 parallel microchannels with a hydraulic diameter of 0.89 mm and a length of 30 mm. The experiments were conducted over a base heat flux between 2 and 117 W/cm 2 (based on the footprint area), mass velocity of 282–1033 kg/m 2 s, the saturation temperature ranged from 27.2 to 35.5 °C, exit vapor quality up to 0.45 and an inlet sub-cooling approximately 3 °C. The effects of mass velocity, saturation temperature, and heat flux, on the flow boiling characteristics were analyzed and discussed. Results demonstrated that the heat transfer coefficient (HTC) rise with the increase of mass flux under middle and high heat flux. At the maximum mass velocity of 1033 kg/m 2 s, the flow boiling HTC reached 51456 W/m 2 K. Moreover, the pressure drop increased with higher mass and heat flux, while it decreased with increasing saturation temperature. Additionally, under high heat flux conditions, the two-phase flow became more stable, and the wall surface temperatures exhibited greater uniformity when higher mass velocity or saturation temperature was applied. The visualization results illustrated that there were four flow patterns and reverse flow occurred when R exceeded unity. Finally, the experimental results were evaluated with six previous heat transfer correlations. An improved predictive model for flow boiling HTC was developed and good agreement with present data was obtained with MAE of 9.08 %. A two-phase micro-channels cold plate for high-power density electronic components could be rationally designed and optimized with reference to this work.
engineering, mechanical,thermodynamics,mechanics