Abstract:The flow condensation heat transfer coefficient of R134a inside two helical micro-fin tubes with outer diameter of 6.35 mm and helical angles of 18o and 28o respectively were experimentally studied at a high mass flux ranging from 500 to 1100 kg m−2 s−1. The condensation temperatures are 35°C, 40°C and 45°C, and the vapor qualities ranges from 0.95 to 1.00 at the inlet section and from 0.00 to 0.05 at the outlet section. Experimental results show that there are annular and intermittent flow regimes inside the tube under experimental conditions, the ratio of annular flow region to the total heat transfer region is about 70%. The liquid film flow changes from rotational flow to coexistence of rotational and horizontal flows when the vapor quality is 0.475±0.08, 0.486±0.06 and 0.521±0.05, respectively and the corresponding saturation temperature is 35°C, 40°C and 45°C. Based on the experimental data, the heat transfer coefficient increases with increasing mass flux and fin helical angle, and with decreasing saturation temperature and Reynolds number of cooling water. In addition, the heat transfer coefficient of annular flow is greater than that of intermittent flow, in other words, the heat transfer coefficient increases with increasing vapor quality. The heat transfer coefficient obtained at high mass flux was compared with the calculated data of some published correlations used at low mass flux. It was found that most correlations underestimate the experimental heat transfer coefficient inside the micro-fin tube, and these prediction deviation increases with increasing mass flux and fin helical angle. By introducing some dimensionless numbers as well as considering the flow mechanism of liquid film inside the tube, two heat transfer coefficient correlations were proposed based on the experimental data. The ratio of liquid film thickness to fin height was used to characterize whether the liquid film flow is rotational flow or coexistence of rotational and horizontal flows in the proposed correlation, which shows a better prediction accuracy with a mean deviation of less than 7.3%.

A General Correlation for Heat Transfer During Saturated Boiling with Flow Across Tube Bundles

A General Correlation for Saturated Two-Phase Flow Boiling Heat Transfer Inside Horizontal and Vertical Tubes

Prediction of Critical Heat Flux in Tube Bundles With Crossflow

Heat Transfer Correlations for Single-Phase Flow, Condensation, and Boiling in Microfin Tubes

A Modified Correlation for Flow Boiling Heat Transfer in Plate Heat Exchangers

Study of Heat Transfer for Co2 Flow Boiling in Horizontal Small Diameter Tubes

A New Heat Transfer Model for Flow Boiling of Refrigerants in Micro-Fin Tubes

A GENERAL CORRELATION FOR FRICTIONAL PRESSURE DROP OF FLOW BOILING IN PLATE HEAT EXCHANGERS

Flow boiling pressure drop correlation in small to micro passages

Experimental Study of Condensation Heat Transfer of R134a Inside the Micro-Fin Tubes at High Mass Flux

A New Correlation For Subcooled Flow Boiling Heat Transfer In A Vertical Narrow Microchannel

Development of a New Correlation for Saturated Flow Boiling Heat Transfer in a Helically Coiled Tube

Study on Flow Boiling of Refrigerants in Micro/Mini-Channels

Flow Boiling Heat Transfer of R134a in a Horizontal Smooth Tube: Experimental Results, Flow Patterns, and Assessment of Correlations

Heat Transfer Correlations For Condensation In Three-Dimentional Surface Enhanced Heat Transfer Tubes

Frictional Pressure Drop During Flow Boiling in Micro-Fin Tubes: A New General Correlation

NEW FLOW-PATTERN-BASED HEAT TRANSFER CORRELATIONS FOR WATER IN MICRO/MINICHANNELS

Assessment of two-phase heat transfer coefficient and critical heat flux correlations for cryogenic flow boiling in pipe heating experiments

Heat transfer correlation of smooth inverted annular film boiling in a circular tube

Correlations for Saturated Critical Heat Flux in Microchannels

Two-phase Heat Transfer Correlations in Three-Dimensional Hierarchical Tube