Abstract:Thin film bulk acoustic resonator (FBAR) plays a very important role in radio frequency (RF) filters used in cell phone and other wireless systems. Although FBAR is commercialized, the design/process interactions on the frequency response variation in FBAR device are still lacking. Design and fabrication are two crucial aspects affecting FBAR device performance. In this report, various solidly mounted resonators (SMR) were designed, fabricated and analyzed to study wafer-level site-to-site RF variation on design and fabrication process. As a key process step for SMR FBAR, the optimization process of Mg-doped ZnO piezoelectric thin film deposition was studied by varying thin film sputtering conditions using various sputtering targets and by post annealing treatment after the deposition. The quality of this crucial layer was verified by XRD on its (0 0 2) crystallization and wafer-level FBAR RF characterization. FBAR devices with high quality were fabricated with an excellent resonant behavior near 2 GHz and a maximum return loss of -15 to 25 dB. Quality factor Q ranges from 400 to 800, with a coupling coefficient keff(2) of 1.5-3%. Wafer-level and wafer-to-wafer variation of central frequency are within 1.8-2.1 GHz. Computer simulation verified that this frequency variation correlates to the piezoelectric film variation of 1.6-1.9 mu m. Process control on this piezoelectric thin film is essential to maintaining the resonator frequency-controlled value when building duplexer RF circuits. The dependency of RF performance on FBAR size, density and orientation is not obvious, compared to that of the wafer-level FBAR device variation on fabrication process. Regarding to the Mg-doping effect in MgxZn1-xO piezoelectric film, the amount of Mg in MgxZn1-xO film during the sputtering process must be properly controlled within 30% to keep the piezoelectric quality. The average acoustic speed of the Mg-doped ZnO film is 6870 m/s with the estimated range of 5760-7980 m/s, which is better than that of pure ZnO film (6330 m/s).

Analysis and verification on second-order nonlinearity in radio frequency bulk acoustic wave devices employing temperature compensation films

Nonlinear Distortion and Its Analysis on Radio Frequency Thin Film Bulk Acoustic Devices

Second-order Nonlinearity of Amorphous SiOF Films in FBARs

Analytical and experimental study on the second harmonic mode response of a bulk acoustic wave resonator

Use of Fluorine-Doped Silicon Oxide for Temperature Compensation of Radio Frequency Surface Acoustic Wave Devices.

Design and Fabrication of Temperature-Compensated Film Bulk Acoustic Resonator Filter Based on the Stress Compensation Effect

Perturbation Analysis of Second-Order Nonlinearity and Its Effectiveness for Radiofrequency Bulk Acoustic Wave Devices

HBAR sensor based on ALN thin films acoustic bulk wave resonator

Development of film bulk acoustic wave resonators based on piezoelectric aluminum nitride

A Multiple Resonant Mode Film Bulk Acoustic Resonator Based on Silicon-On-Insulator Structures

Processing chip for thin film bulk acoustic resonator mass sensor

Design and Implementation of low phase noise oscillator based on film bulk acoustic resonator

Design and modelling of thin film bulk acoustic resonator (FBAR) for RF application

Progress of Research on the Thin-film Bulk Acoustic Resonator

Process Optimization and Device Variation of Mg-doped ZnO FBARs

High- Q film bulk acoustic resonator with high quality AlN film based on transfer method

High-Performance Film Bulk Acoustic Resonator and Filter Based on an Al $_{\text{0.8}}$ Sc $_{\text{0.2}}$ N Film Prepared by a Low-Temperature Staged Deposition Method

Perturbation analysis of nonlinear responses caused by transverse modes in AlN FBAR based on 2D scalar wave model

High coupling coefficient Temperature compensated FBAR resonator for oscillator application with wide pulling range

Suppression of Transverse-Mode Spurious Responses by Selectively SiO2 Removing Technique for SAW Resonators on a SiO2/Al/LiNbO3 Structure

Impedance-matched High-overtone Bulk Acoustic Resonator