Abstract:The rapid development of the next-generation high-speed wireless communication system has set increasingly stringent requirements on the spectral purity of local RF oscillators. Low phase noise is crucial to support advanced modulation scheme enabling high data-rates wireless link [1]. A viable popular approach is to coupled N identical oscillators together to improve the phase noise by 10log <inf xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">10</inf> N at the cost of N times higher power [2]–[6]. Nevertheless, the coupling network needs to be designed carefully to avoid undesired multi-tone concurrent oscillations. Besides, area occupation is another issue of multi-core VCOs. The star-geometry as shown in Fig. 1. (bottom left), which is simple N times duplication of single core, occupies N times larger area so comes with an area penalty [3]–[5]. To solve this problem, circular geometry is proposed where the passives are merged into a single passive structure and the minimal realizable inductance is reduced while keeping a high Q factor [6]–[7]. In order to further reduce the silicon area, a square-geometry quad-core oscillator with inductor sharing technique is proposed in this paper and it exhibits a compact area of 0.09 mm <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> , which is the smallest quad-core VCO operating at a similar oscillation frequency. The unwanted mode is suppressed by the metal trace that connects the drain node of adjacent cores. Thanks to the proposed square-geometry and inductor sharing technique, the proposed quad-core class-F VCO can further reduce the area occupation. The proposed VCO is fabricated in 65nm CMOS technology. The measured phase noise is -137.2 dB/Hz at 10 MHz offset frequency from a carrier of 19 GHz, which translates to the FoM of 186.1 dBc/Hz.

Design and Implementation of low phase noise oscillator based on film bulk acoustic resonator

A novel oscillator based on film bulk acoustic resonator

A LOW POWER, LOW PHASE NOISE FBAR OSCILLATOR

A Film Bulk Acoustic Resonator (FBAR) L Band Low Noise Oscillator for Digital Communications

A Low Phase Noise VCO with Placement Reordered Cores and High-Q Bond Wire Array Inductors

Substrate Integrated High-Q Dielectric Resonators for Low Phase Noise Oscillator

Processing chip for thin film bulk acoustic resonator mass sensor

Laser Frequency Trimming Technology Based on FBAR

Dielectric Resonators with High $Q$-Factor for Tunable Low Phase Noise Oscillators

Electrically Tunable Film Bulk Acoustic Resonator Based On Au/Zno/Al Structure

A Design Approach for High-Q FBARs with Double Frames

Progress of Research on the Thin-film Bulk Acoustic Resonator

Design and modelling of thin film bulk acoustic resonator (FBAR) for RF application

Modeling of RF Filter Component Based on Film Bulk Acoustic Resonator

A Multiple Resonant Mode Film Bulk Acoustic Resonator Based on Silicon-On-Insulator Structures

Design and Fabrication of a Film Bulk Acoustic Wave Filter for 3.0 GHz–3.2 GHz S-Band

Numerical Investigation of Phononic Crystal Based Film Bulk Acoustic Wave Resonators

Film Bulk Acoustic Resonators Integrated on Arbitrary Substrates Using a Polymer Support Layer.

Design of Balanced RF Filter for Wireless Applications Using FBAR Technology

A Compact Square-Geometry Quad-Core 19 GHz Class-F VCO with Parallel Inductor-sharing Technique achieving -137.2 dBc/Hz Phase Noise at 10MHz Offset

Flexible structured high-frequency film bulk acoustic resonator for flexible wireless electronics