Abstract:The insulation condition is the key to determining whether gas insulated switchgears (GISs) can operate stably and reliably. Partial discharge (PD) detection is an important technique for condition monitoring and evaluation in GIS. Acoustic emission (AE) method is commonly used in on-site PD detection. However, in field applications, there are often problems such as low signal-to-noise ratio (SNR) of measured ultrasonic signals and difficulty in extracting PD pulses. To solve this problem, a denoising method for GIS ultrasonic signals based on the combination of ultrasonic and ultra-high frequency (UHF) signals is proposed in this paper. Based on the difference in correlation between noise and PD signals, the noise in measured signal can be suppressed through accumulating and averaging of multiple ultrasonic signals, and the SNR of PD signal can be significantly improved. An actual 500-kV GIS experiment platform is established, and PD measurements for different types of defects are conducted. Then, a comparative study is conducted on the denoising performance of the proposed method and traditional denoising methods such as wavelet method and singular value decomposition (SVD) method. The results indicate that compared to traditional methods, the method proposed in this paper has a higher reduction in noise level. Especially for extremely low-SNR signals (PD pulses buried in noise), traditional methods have poor performance, while the proposed method can still extract the PD pulse form the noise. Furthermore, based on the denoised ultrasonic signals, the defect localization analysis is conducted to demonstrates the correctness of the denoising results. Finally, the proposed method is applied to on-site PD detection, which further evaluates the effectiveness of the denoising method.

Research on Partial Discharge Detection of Switchgear Based on Ultrasonic Signal Characteristic

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Partial discharge detection, diagnosis, and location technology based on a novel transient earth voltage-ultrasonic integrated sensor used for switchgear equipment

Examination and Research on the Partial Discharge Fault Diagnostics in Gas Insulated Switchgear

Partial Discharge Detection Technology for Switchgear Based on Near-Field Detection

Partial Discharge Diagnostics: Data Cleaning and Feature Extraction

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization

Diagnosis of Partial Discharge Based on the Air Components for the 10 kV Air-Insulated Switchgear

Review of research on partial discharge detection techniques of high voltage switchgear

Research on the Typical Partial Discharge Using the UHF Detection Method for GIS

Diagnosis of Partial Discharge in GIS Based on UHF Sensing Technique

Uhf Signal Processing and Pattern Recognition of Partial Discharge in Gas-Insulated Switchgear Using Chromatic Methodology

Partial Discharge Detection and Defect Location Method in GIS Cable Terminal

Partial Discharge Source Localization in GIS Based on Image Edge Detection and Support Vector Machine

Research on Imaging Technology of Ultrasonic Echo Applied to Live Detection of Switchgear Insulation Defects

Identification of ultra‐high‐frequency PD signals in gas‐insulated switchgear based on moment features considering electromagnetic mode

Identification of Partial Discharge Based on Composite Optical Detection and Transformer-Based Deep Learning Model

Investigation of disc-type sensors using the UHF method to detect partial discharge in GIS

Gas Insulated Switchgear Partial Discharge Type Identification Based on Frequency Division Features and Improved Long Short-Term Memory Neural Networks

Partial Discharge Ultrasound Detection Using the Sagnac Interferometer System

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis