Abstract:Objective In order to find early latent faults and prevent catastrophic failures, diagnosis of insulation condition by measuring technique of partial discharge(PD) in gas insulated switchgear (GIS) is applied in this paper, which is one of the most basic ways for diagnosis of insulation condition. Methods Ultra high frequency(UHF) PD detection method by using internal sensors has been proved efficient, because it may avoid the disturbance of corona, but the sensor installation of this method will be limited by the structure and operation condition of GIS. There are some of electromagnetic (E-M) waves leak from the place of insulation spacer, therefore, the external sensors UHF measuring PD technique is applied, which isn't limited by the operation condition of GIS. Results This paper analyzes propagated electromagnetic (E-M) waves of partial discharge pulse excited by using the finite-difference time-domain (FDTD) method. The signal collected at the outer point is more complex than that of the inner point, and the signals' amplitude of outer is about half of the inner, because it propagates through spacer and insulation slot. Set up UHF PD measuring system. The typical PD in 252kV GIS bus bar was measured using PD detection UHF technique with external sensors. Finally, compare the results of UHF measuring technique using external sensors with the results of FDTD method simulation and the traditional IEC60270 method detection. Conclusion The results of experiment shows that the UHF technique can realize the diagnosis of insulation condition, the results of FDTD method simulation and the result UHF method detection can demonstrate each other, which gives references to further researches and application for UHF PD measuring technique.

Research on Imaging Technology of Ultrasonic Echo Applied to Live Detection of Switchgear Insulation Defects

Ultrasonic Guided Wave-Based Switch Rail Monitoring Using Independent Component Analysis

Feasibility Research of Defect Testing for Basin Insulator Based on Ultrasonic Guided Wave

GIS Mechanical State Identification and Defect Diagnosis Technology Based on Self-Excited Vibration of Assembled Circuit Breaker

Research and Application of Ultrasonic Stress Detection Method for Insulation Defects of High Voltage Switchgear

Research on Partial Discharge Detection of Switchgear Based on Ultrasonic Signal Characteristic

Research on Acousto-optic Joint Detection and Visual Diagnosis Method of Power Equipment

An Ultrasonic Pulse-Echo Method to Detect Internal Defects in Epoxy Composite Insulation

A Classification System for Insulation Defect Identification of Gas-Insulated Switchgear (GIS), Based on Voiceprint Recognition Technology

Research on insulation state evaluation and detection technology for 40.5 kV switchgear wall bushing

Study on the Ultrasonic Detection Method for Internal Defects of Insulation Pull Rod in Circuit Breakers

Partial discharge detection, diagnosis, and location technology based on a novel transient earth voltage-ultrasonic integrated sensor used for switchgear equipment

Ultrasonic Detection and Diagnostic Method for the Internal Defects in Epoxy Composite

Application Prospect of Ultrasonic Testing Methods to Internal Stress in Basin Insulators for GIS

Detection of Internal Defects of Full-Size Composite Insulators Based on Microwave Technique

On-line Condition Monitoring System of Medium-Voltage Switchgear

THE STUDY ON MEASURING TECHNIQUE OF PARTIAL DISCHARGE IN GAS INSULATED SWITCHGEAR USING ULTRA HIGH FREQUENCY METHOD WITH EXTERNAL SENSORS

Fault Classification System for Switchgear CBM from an Ultrasound Analysis Technique Using Extreme Learning Machine

Research on 1 100 kV GIS Partial Discharge Fault Location Based on UHF Technology

Research on Partial Discharge Monitoring System of Switchgear Based on Wireless Distributed TEV Sensors

Development of On-line Monitoring System of Medium Voltage Switchgear