Abstract:The insulation condition is the key to determining whether gas insulated switchgears (GISs) can operate stably and reliably. Partial discharge (PD) detection is an important technique for condition monitoring and evaluation in GIS. Acoustic emission (AE) method is commonly used in on-site PD detection. However, in field applications, there are often problems such as low signal-to-noise ratio (SNR) of measured ultrasonic signals and difficulty in extracting PD pulses. To solve this problem, a denoising method for GIS ultrasonic signals based on the combination of ultrasonic and ultra-high frequency (UHF) signals is proposed in this paper. Based on the difference in correlation between noise and PD signals, the noise in measured signal can be suppressed through accumulating and averaging of multiple ultrasonic signals, and the SNR of PD signal can be significantly improved. An actual 500-kV GIS experiment platform is established, and PD measurements for different types of defects are conducted. Then, a comparative study is conducted on the denoising performance of the proposed method and traditional denoising methods such as wavelet method and singular value decomposition (SVD) method. The results indicate that compared to traditional methods, the method proposed in this paper has a higher reduction in noise level. Especially for extremely low-SNR signals (PD pulses buried in noise), traditional methods have poor performance, while the proposed method can still extract the PD pulse form the noise. Furthermore, based on the denoised ultrasonic signals, the defect localization analysis is conducted to demonstrates the correctness of the denoising results. Finally, the proposed method is applied to on-site PD detection, which further evaluates the effectiveness of the denoising method.

Partial Discharge Source Localization in GIS Based on Image Edge Detection and Support Vector Machine

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

SVM-based Partial Discharge Pattern Classification for GIS

Discrimination of Three or More Partial Discharge Sources by Multi-Step Clustering of Cumulative Energy Features

Partial Discharge Inversion Localization Method for GIS Based on Twin Database

Application of SCNGO-VMD-SVM in Identification of Gas Insulated Switchgear Partial Discharge

Diagnosis of Partial Discharge in GIS Based on UHF Sensing Technique

A Novel Partial Discharge Localization Method for GIL Based on the 3D Optical Signal Irradiance Fingerprint and Bagging‐kelm

Examination and Research on the Partial Discharge Fault Diagnostics in Gas Insulated Switchgear

Partial Discharge Fault Diagnosis Based on Zernike Moment and Improved Bacterial Foraging Optimization Algorithm

A Denoising Method for Partial Discharge Ultrasonic Signals in GIS Based on Ultra-High Frequency Signal Synchronization

Research on the Typical Partial Discharge Using the UHF Detection Method for GIS

On Site Detection and Localization of Partial Discharge in Hydropower Plant GIL/GIS Based on Ultra-high Frequency Technique

Statistical Feature Extraction Combined with Generalized Discriminant Component Analysis Driven SVM for Fault Diagnosis of HVDC GIS

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

A Novel Optical Localization Method for Partial Discharge Source Using ANFIS Virtual Sensors and Simulation Fingerprint in GIL

Partial Discharge Detection and Defect Location Method in GIS Cable Terminal

Investigation of Frequency Characteristics of Typical PD and the Propagation Properties in GIS

Uhf Signal Processing and Pattern Recognition of Partial Discharge in Gas-Insulated Switchgear Using Chromatic Methodology

Propogation Characteristics of PD‐induced UHF Signal in 126 Kv GIS with Three‐phase Construction Based on Time–frequency Analysis

Research on Partial Discharge Detection of Switchgear Based on Ultrasonic Signal Characteristic