Abstract:Partial discharge (PD) is a common phenomenon in high voltage (HV) equipment, which will radiate light signals outward in the process of discharge, by detecting this optical signal, we can judge whether the HV equipment have PDs or not, the conventional detection methods under impulse voltage are very complex due to the interference of electromagnetic (EM) wave, but optical method does not have this problem. Fluorescent optical fiber is not affected by numerical aperture problem, so the sensitivity of fluorescent optical fiber sensor is much higher than that of traditional quartz optical fiber sensor. In this work, the fluorescent optical fiber sensor was manufactured and applied to the PD detection in gas insulated switch (GIS) and transformer, fluorescent optical fiber was used as a probe, which was connected with the transmission optical fiber by coupler, and the photomultiplier tube was used to convert the optical signal into electrical signal for displaying by oscilloscope. The discharge signal can be detected by the sensor when the impulse voltage was applied to the GIS and transformer, and it was less affected by the interference of EM wave signals. As the PD source at different positions in GIS, we found that the optical signal attenuates greatly when the optical was blocked by some internal structures, and the attenuation was increase with the increase of distance between PD source and the sensor. The optical signals of PDs can also be detected by the sensor in the transformer, but the attenuation of the optical signal in the transformer was greater than that in GIS, it was greatly affected by the blocking of windings. The two experiments were verified in the TracePro simulation software, and the average deviations between results of experiments and simulations were less than 10%.

Investigation of disc-type sensors using the UHF method to detect partial discharge in GIS

Partial discharge diagnosis by simultaneous observation of discharge pulses and vibration signal

Diagnosis of Partial Discharge in GIS Based on UHF Sensing Technique

Investigation on the Sensitivity of the UHF Method for Partial Discharge Detection in GIS

Investigation of the Evaluation of the Pd Severity and Verification of the Sensitivity of Partial-Discharge Detection Using the Uhf Method in Gis

Examination and Research on the Partial Discharge Fault Diagnostics in Gas Insulated Switchgear

Investigation of Frequency Characteristics of Typical PD and the Propagation Properties in GIS

The Study on a New Method for Detecting Corona Discharge in Gas Insulated Switchgear

Research on the Typical Partial Discharge Using the UHF Detection Method for GIS

Passive Wireless Partial Discharge Sensors with Multiple Resonances

Influence of the Structure Dimension of Gis on the Partial Discharge

A Novel Composite Sensor for UHF Partial Discharge and Gas State Measurement in GIS

Analysis Of The Intrinsic Characteristics Of The Partial Discharge Induced By Typical Defects In Gis

Partial discharge detection, diagnosis, and location technology based on a novel transient earth voltage-ultrasonic integrated sensor used for switchgear equipment

On Site Detection and Localization of Partial Discharge in Hydropower Plant GIL/GIS Based on Ultra-high Frequency Technique

The Characteristics and Detection of the Partial Discharge Induced by the Micro Cracks in GIS Insulators

Relationship Between Time-Frequency Representation of PD-induced UHF Signal and PD Current Pulse

Partial Discharge Detection Technology for Switchgear Based on Near-Field Detection

Propogation Characteristics of PD‐induced UHF Signal in 126 Kv GIS with Three‐phase Construction Based on Time–frequency Analysis

Evaluation of the UHF Method Based on the Investigation of a Partial Discharge Case in Post Insulators

Detection of Partial Discharge in GIS and Transformer Under Impulse Voltage by Fluorescent Optical Fiber Sensor