Abstract:Hydrogen gas is an ideal fuel due to its higher calorific value among fuels and minimal environmental impact on their energy applications. However, the high cost around high reactivity, explosion risks and extremely low energy density, make it unfeasible to be used as fuel in large quantities scale. There are some possibilities to circumvent these limitations, including obtaining and converting energy through fuel cells, which is very promising. Research in this field has been summarized in recent decades, motivated by the environmental problems faced due to the dependence on non-renewable energy matrices. From this, this study aimed to improve the steam methanol reforming using CuO/ZnO/Al2O3 catalyst. The catalyst was characterized by atomic absorption spectroscopy, N2 physisorption and XRD. Catalytic tests were carried out in a laboratory scale fixed bed reactor at 300°C, atmospheric pressure and in differential conditions (methanol conversion < 10%); a previous run for catalyst synthesis validation in relation to the results obtained in the literature for the same conditions was evaluated. Subsequently, it was found that the thermal degradation of methanol at 300°C without the presence of the catalyst was negligible, and then operational conditions were established to obtain methanol conversions lower than 10%. Then, the initial deactivation of the catalyst over 31h. Also identifying the stability after 7 h in reaction with average conversion into 9.7% of methanol, showing high stability, in addition to good reproducibility on the part of synthesis in optimal composition. Then, experiments were carried out for the molar ratios 2:1 and 4:1 with methanol conversions of 15.5% and 6.6%, respectively. Note that performing the average of the 4:1 and 2:1 methanol conversion in 14.6% obtained at indicating that the upper boundary molar ratios (4:1) compensates for the conversion reduction in 2:1, achieving a result superior to the reference 3:1.

Statistical optimization of hydrogen production from bio-methanol steam reforming over Ni-Cu/Al2O3 catalysts

An Innovative Micro-Channel Catalyst Support with a Micro-Porous Surface for Hydrogen Production Via Methanol Steam Reforming

Effective Hydrogen Production from Partial Oxidation of Propane over Composite Ni/Al2O3-SiC Catalyst

Optimization for hydrogen production from methanol partial oxidation over Ni–Cu/Al2O3 catalyst under sprays

A Thermally Autonomous Methanol Steam Reforming Microreactor with Porous Copper Foam As Catalyst Support for Hydrogen Production

Studies on Ni/Al2O3 Catalyst for Hydrogen Production from Ethanol Steam Reforming

Producing hydrogen by catalytic steam reforming of methanol using non-noble metal catalysts

Ni-based bimetallic catalysts for hydrogen production via (sorption-enhanced) steam methane reforming

Hydrogen Production Via Steam Reforming of Methanol on Cu/ZnO/Al2O3 Catalysts: Effects of Al2O3 Precursors

Synthesis and regeneration of mesoporous Ni–Cu/Al2O4 catalyst in sub-kilogram-scale for methanol steam reforming reaction

Hydrogen Production from the Steam Reforming of Biogas over Ni-based Catalyst: the Role of Promoters and Supports

Hydrogen Production from Ethanol Steam Reforming over Ni/Al2O3 and Ni/La2O3 Catalysts at Low Temperature

Renewable hydrogen production from steam reforming of glycerol by Ni–Cu–Al, Ni–Cu–Mg, Ni–Mg catalysts

Steam reforming of ethanol for hydrogen production: influence of catalyst composition (Ni/Al2O3, Ni/Al2O3–CeO2, Ni/Al2O3–ZnO) and process conditions

Effects of Preparation Method on the Performance of Ni/Al 2 O 3 Catalysts for Hydrogen Production by Bio-Oil Steam Reforming

Insights into the Mechanism of Methanol Steam Reforming for Hydrogen Production over Ni–Cu-Based Catalysts

A review on ethanol steam reforming for hydrogen production over Ni/Al2O3 and Ni/CeO2 based catalyst powders

Evaluation of feeding molar rate in mini fixed bed reactor for methanol steam reforming with pre-optimized composition of CuO/ZnO/Al2O3 catalyst

Hydrogen Production from Steam Reforming of Ethanol Using Ni/CeO2 and Ni-Cu/CeO2 Catalysts

Synthesis and characterization of nickel based bimetallic nano catalyst for production of clean hydrogen by steam reforming of glycerol