Abstract:<div><div>Electric vehicles (EV’s) present new challenges to achieving the required noise, vibration & harshness performance (NVH) compared with conventional vehicles. Specifically, high-frequency noise and unexpected noise phenomenon, previously masked by the internal combustion engine can cause annoyance in an EV. Electric motor (E-motor) whine noise caused by electromagnetic excitation during E-motor operation is caused by torque ripple and radial excitation. Under high speed and high load operating conditions, the overall sound level may be low, however high frequency whine noise can impair the vehicle level NVH performance. An example of a previously masked unexpected noise phenomenon is a droning noise that can be caused by manufacturing quality variation of the spline coupling between the rotor shaft of the E-motor and the input shaft of the reducer. It is dominated by multiple higher orders of the E-motor rotation frequency.</div><div>In this study, the high speed and high load condition whine noise problem was reproduced through electromagnetic and structural analysis. The countermeasures (E-motor geometry refinements to reduce the excitations and mechanical system transfer path modifications to reduce the vibration response) were defined and the effects investigated. Mechanical system modification to improve NVH performance without increasing the mass is challenging. However, E-motor air-gap geometry optimization, such as slot opening modulation and rotor notch modifications achieved significant noise reduction without critical trade-off of other performance.</div><div>This paper also describes the basic improvement plan proposed through the simulation of the droning noise behavior. The main two manufacturing errors (pitch error in the spline coupling and the alignment error between the rotor and the gearbox shafts) that are responsible for the unexpected droning noise were identified. Using simulation it was shown that the droning noise can be reduced through improved quality control and tolerance design optimization of factors such as axis self-alignment and spline gear tooth quality.</div></div>

Introduction to Ansys NVH solutions focusing on the Vibro Acoustics

Application of Acoustic Transfer Vector Algorithm on Acoustic Radiation for Drive Axle of Automobile

Automotive NVH Technology

Case study of automotive NVH topics induced by HVAC systems integration

A Study on the Noise and Vibration Testing System for Automotive Final Drive

Auralization of road noise CAE simulation results for interactive sound quality evaluations

Vibration transfer path analysis and path ranking for NVH optimization of a vehicle interior

Enhancement of Full-Vehicle Road Noise Simulation Including Detailed Road Surface and Innovative Tire Modeling

NVH investigation of automotive HVAC brushless motors

Nvh Control Strategy Of Plug-In Electric Vehicles

Describing Road Booming Noise with a Hybrid Simulation Model Using a Time Segmentation of the Excitation Load Approach

Virtual Accelerometer Approach to Create Vibration Profile for Automotive Component Shake Test

Robust Development of Electric Powertrain NVH for Compact Electric SUV

Interactive Visual Analysis of Structure-borne Noise Data

Design and validation of dynamic characteristics of vibration of test fixture for automobile application

Evaluation of steering wheel vibration in electric vehicles and application to Dynamic Motor Drive

Dynamic NVH Numerical Analysis of Power Steering in the Presence of Lubricant in the System

Integrated Solutions for Noise and Vibration Control in Vehicles

Noise radiated by electric motors – simulation process and overview of the optimization approaches

Reducing Body Development Time by Integrating NVH and Durability Analysis from the Start

Challenges of achieving better NVH performance for Chinese domestic brands