Abstract:<div><div>Electric vehicles (EV’s) present new challenges to achieving the required noise, vibration & harshness performance (NVH) compared with conventional vehicles. Specifically, high-frequency noise and unexpected noise phenomenon, previously masked by the internal combustion engine can cause annoyance in an EV. Electric motor (E-motor) whine noise caused by electromagnetic excitation during E-motor operation is caused by torque ripple and radial excitation. Under high speed and high load operating conditions, the overall sound level may be low, however high frequency whine noise can impair the vehicle level NVH performance. An example of a previously masked unexpected noise phenomenon is a droning noise that can be caused by manufacturing quality variation of the spline coupling between the rotor shaft of the E-motor and the input shaft of the reducer. It is dominated by multiple higher orders of the E-motor rotation frequency.</div><div>In this study, the high speed and high load condition whine noise problem was reproduced through electromagnetic and structural analysis. The countermeasures (E-motor geometry refinements to reduce the excitations and mechanical system transfer path modifications to reduce the vibration response) were defined and the effects investigated. Mechanical system modification to improve NVH performance without increasing the mass is challenging. However, E-motor air-gap geometry optimization, such as slot opening modulation and rotor notch modifications achieved significant noise reduction without critical trade-off of other performance.</div><div>This paper also describes the basic improvement plan proposed through the simulation of the droning noise behavior. The main two manufacturing errors (pitch error in the spline coupling and the alignment error between the rotor and the gearbox shafts) that are responsible for the unexpected droning noise were identified. Using simulation it was shown that the droning noise can be reduced through improved quality control and tolerance design optimization of factors such as axis self-alignment and spline gear tooth quality.</div></div>

Case study of automotive NVH topics induced by HVAC systems integration

NVH investigation of automotive HVAC brushless motors

Introduction to Ansys NVH solutions focusing on the Vibro Acoustics

Nvh Control Strategy Of Plug-In Electric Vehicles

Automotive NVH Technology

Vibration transfer path analysis and path ranking for NVH optimization of a vehicle interior

Challenges of achieving better NVH performance for Chinese domestic brands

Recent progress in battery electric vehicle noise, vibration, and harshness

Integrated Solutions for Noise and Vibration Control in Vehicles

Robust Development of Electric Powertrain NVH for Compact Electric SUV

Modeling of Thermal Dynamics of a Connected Hybrid Electric Vehicle for Integrated HVAC and Powertrain Optimal Operation

Noise and vibration suppression in hybrid electric vehicles: State of the art and challenges

Study and Development of Subjective Evaluation of Inner Noise Quality and Improvement

Evaluation of the airflow distribution of a vertical air ventilation system in a car cabin using PIV measurements and CFD simulations

Optimization of air quality and energy consumption in the cabin of electric vehicles using system simulation

An innovative HVAC control system: Implementation and testing in a vehicular cabin

Analysis and study of the transmission path based on the body and NVH

A Roadmap for intelligent HVAC control in Vehicle Cabin

CFD studies for energy conservation in the HVAC system of a hatchback model passenger car

TRANSFER PATH ANALYSIS AND CONTROL OF AUTOMOTIVE INTERIOR STRUCTURE-BORNE NOISE GENERATED BY A POWERPLANT

Noise radiated by electric motors – simulation process and overview of the optimization approaches