Abstract:<div><div>Electric vehicles (EV’s) present new challenges to achieving the required noise, vibration & harshness performance (NVH) compared with conventional vehicles. Specifically, high-frequency noise and unexpected noise phenomenon, previously masked by the internal combustion engine can cause annoyance in an EV. Electric motor (E-motor) whine noise caused by electromagnetic excitation during E-motor operation is caused by torque ripple and radial excitation. Under high speed and high load operating conditions, the overall sound level may be low, however high frequency whine noise can impair the vehicle level NVH performance. An example of a previously masked unexpected noise phenomenon is a droning noise that can be caused by manufacturing quality variation of the spline coupling between the rotor shaft of the E-motor and the input shaft of the reducer. It is dominated by multiple higher orders of the E-motor rotation frequency.</div><div>In this study, the high speed and high load condition whine noise problem was reproduced through electromagnetic and structural analysis. The countermeasures (E-motor geometry refinements to reduce the excitations and mechanical system transfer path modifications to reduce the vibration response) were defined and the effects investigated. Mechanical system modification to improve NVH performance without increasing the mass is challenging. However, E-motor air-gap geometry optimization, such as slot opening modulation and rotor notch modifications achieved significant noise reduction without critical trade-off of other performance.</div><div>This paper also describes the basic improvement plan proposed through the simulation of the droning noise behavior. The main two manufacturing errors (pitch error in the spline coupling and the alignment error between the rotor and the gearbox shafts) that are responsible for the unexpected droning noise were identified. Using simulation it was shown that the droning noise can be reduced through improved quality control and tolerance design optimization of factors such as axis self-alignment and spline gear tooth quality.</div></div>

NVH investigation of automotive HVAC brushless motors

Case study of automotive NVH topics induced by HVAC systems integration

A Review on Machine Topologies and Control Techniques for Low-Noise Switched Reluctance Motors in Electric Vehicle Applications

Robust Development of Electric Powertrain NVH for Compact Electric SUV

A Novel Control Strategy of Single Phase Brushless DC Motor for Automotive Air Conditioning

Thermal analysis of a fluid immersed brushless DC motor for aerospace applications

Recent progress in battery electric vehicle noise, vibration, and harshness

Dynamic force measurement to assess NVH performance of electric motors

Multi-objective optimization algorithm for optimizing NVH performance of electric vehicle permanent agnet synchronous motors

Nvh Control Strategy Of Plug-In Electric Vehicles

Thermal Analysis of a Brushless DC Motor for Aerospace Application Using Thermal Network Models

Noise and vibration suppression in hybrid electric vehicles: State of the art and challenges

Noise radiated by electric motors – simulation process and overview of the optimization approaches

Introduction to Ansys NVH solutions focusing on the Vibro Acoustics

Analysis of Inter-Turn Short-Circuit Faults in Brushless DC Motors Based on Magnetic Leakage Flux and Back Propagation Neural Network

Design of Electronic Filter for Noise and Vibration Reduction in Brushed DC Motor

Challenges of achieving better NVH performance for Chinese domestic brands

Evaluation of steering wheel vibration in electric vehicles and application to Dynamic Motor Drive

Thermal Analysis of an Interior Permanent Magnet Synchronous Traction Motor for High Speed Railway Applications

Automotive NVH Technology

Modeling and Suppression of Electromagnetic Interference Noise on Motor Resolver of Electric Vehicle