Simplified residual stress and distortion calculations of multi-pass welds and their possible influence on result quality
Jakob Klassen,Thomas Nitschke-Pagel,Klaus Dilger
DOI: https://doi.org/10.1007/s40194-019-00748-7
IF: 2.1
2019-06-07
Welding in the World
Abstract:In operation, residual stresses will superimpose with load stresses affecting service life of welded constructions. Therefore, knowledge of the exact residual stress state is of great interest already in the design state. Experimental determination of residual stresses is possible using destructive and non-destructive methods. Especially for larger structures and small batch sizes destructive measuring techniques can be neglected. Non-destructive methods, however, do have process-specific disadvantages such as the limited resolution. Furthermore, residual stress gradients in the direction of sheet thickness cannot be determined. An alternative approach would be the virtualization of the design using the finite element method (FEM). The application of FEM gives an insight into residual stresses at each point of the computed model, in particular at areas which are not accessible to measurement. However, the use of the FEM for residual stress calculation is subject to certain limits and error sources due to the fine discretization and the high degree of non-linearity. In particular, the calculation of multi-layer welds will reach high computation times, even with high available computing capacities. Therefore, the calculation's practical benefit is hardly recognizable. This known issue is often counteracted with radical simplification of the welding task to be calculated. Simplification approaches such as reduction of layer numbers or semi-transient calculations result in manageable computing times, but can also lead to result accuracies, the quality of which must be questioned. This led to the following questioning. Which simplification strategies are applicable in numerical welding simulation in order to achieve acceptable accuracy by means of an application-oriented manner? For this purpose, reference models were produced that were experimentally verified. On this basis, simplification approaches were investigated numerically and their effects on result quality were quantified. It could be shown that most of the commonly used simplification approaches for the calculation of residual stresses and distortions are only partially permissible, if any.
metallurgy & metallurgical engineering