Abstract:Accurate prediction of welding residual stresses is often challenging due to the complexity of the welding process which includes moving heat source, temperature-dependent material properties etc. Over the past two decades or so, the numerical simulation technologies have been widely used in the welding process and a number of numerical models have been proposed to predict temperature field and residual stresses field induce by welding process. In the previous numerical simulations, the weldment was either in Free State or rigidly constrained. Such manipulations can not reflect the realistic constraint conditions of the weldment. In this simulation, clamps and backing board are all included in the model as elastic body and analytical rigid body, respectively. In the thermal analysis, the thermolysis of clamps and backing board can be equivalent to forced convection heat transfer, where the coefficients of forced convection heat transfer are temperature dependent; in the mechanical analysis, both the contact interaction between clamps and weldment and the contact interaction between backing board and weldment are considered, normal and tangent contact interaction properties are assumed as "HARD" contact and Coulomb friction, respectively. After welding process, residual compressive plastic strains existing in the weld zone and HAZ are the sources of residual stresses. Post welding cold rolling is an effective and convenient method to reduce residual compressive plastic strains induces by welding especially for thin-walled structure. In the previous researches, either welding process and cold rolling process were treated as two separate processes or only the residual stresses induced by welding process was considered as initial condition in the cold rolling process. In this simulation, welding residual stresses, plastic strains and deformations are all imported as the initial state of the cold rolling process to increase the accuracy of the numerical simulation. The import of plastic strains will affect the accuracy of the numerical simulation for the material which has obvious work harden effect.

Numerical Investigation on Reduction Characteristics of Welding Deformation According to Standoff Distance in Heat Sink Welding Process

Simulation and prediction for welding deformation on welding procedure of hand pallet truck

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Sensitivity Analysis of Some High Efficiency Computational Methods for Welding Process Numerical Simulation

Reductions in the Laser Welding Deformation of STS304 Cylindrical Structure Using the Pre-Stress Method

Numerical simulation and welding parameters optimization for minimum deformation of AHSS based on RSM & QGA

Impact Analysis of Welding Sequence to Reduce Weld Deformation in Aluminum Hulls

Influence of Multi-Beam Preheating Temperature and Stress on the Buckling Distortion in Electron Beam Welding

Optimization of welding parameters on welding distortion and stress in S690 high-strength steel thin-plate structures

Welding simulation using a reduced order model for efficient residual stress evaluation

Numerical Analysis on Optimizing Welding Sequence of Large-Sized Bottom Structure for Controlling Welding Distortion

Controlling of Welding Residual Stress and Deflection Distortion for Flat Plate by Longitudinal Pre-stress Method

High precision modeling of welding and post welding cold rolling continuous process in numerical simulation

Numerical simulation of small section rectangular tube in parallel welding

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Influence of welding sequences and boundary conditions on residual stress and residual deformation in DH36 steel T-joint fillet welds

Three Dimension Simulation Analysis of the Interpass Stress and Deformation During Multipass Welding

Study of Welding Inherent Deformations in Thin Plates Based on Finite Element Analysis Using Interactive Substructure Method

Numerical Study on the Effectiveness of Fixture and Pre-Strain for Reduction of Welding Distortion

Numerical Simulation of Welding for Residual Stress Prediction of Low Carbon Steel

Numerical simulation of three-dimension stress field in double-sided double arc multipass welding process