Abstract:Accurate prediction of welding residual stresses is often challenging due to the complexity of the welding process which includes moving heat source, temperature-dependent material properties etc. Over the past two decades or so, the numerical simulation technologies have been widely used in the welding process and a number of numerical models have been proposed to predict temperature field and residual stresses field induce by welding process. In the previous numerical simulations, the weldment was either in Free State or rigidly constrained. Such manipulations can not reflect the realistic constraint conditions of the weldment. In this simulation, clamps and backing board are all included in the model as elastic body and analytical rigid body, respectively. In the thermal analysis, the thermolysis of clamps and backing board can be equivalent to forced convection heat transfer, where the coefficients of forced convection heat transfer are temperature dependent; in the mechanical analysis, both the contact interaction between clamps and weldment and the contact interaction between backing board and weldment are considered, normal and tangent contact interaction properties are assumed as "HARD" contact and Coulomb friction, respectively. After welding process, residual compressive plastic strains existing in the weld zone and HAZ are the sources of residual stresses. Post welding cold rolling is an effective and convenient method to reduce residual compressive plastic strains induces by welding especially for thin-walled structure. In the previous researches, either welding process and cold rolling process were treated as two separate processes or only the residual stresses induced by welding process was considered as initial condition in the cold rolling process. In this simulation, welding residual stresses, plastic strains and deformations are all imported as the initial state of the cold rolling process to increase the accuracy of the numerical simulation. The import of plastic strains will affect the accuracy of the numerical simulation for the material which has obvious work harden effect.

Numerical simulation of small section rectangular tube in parallel welding

Numerical simulation of welding temperature fields and deform was applied for square-tube

Simulation and Analysis on Longitudinal TIG Welding of TC4 Titanium Alloy Thin-walled Circular Tube

Numerical Simulation of Tube-Plate Welding Structure with T-Shaped Sections

Numerical Simulation Analysis of Residual Stress in Welded Hollow Spherical Joint with Circular Steel Tubes

Numerical simulation of welding deformation in weld on thin low carbon steel plate

Numerical Simulation of Welding Residual Stress of Tube-to-tubesheet Joint in Heat Exchangers

Numerical Simulation and Experimental Validation of Angular Distortion and Residual Stresses in A T-Joint

Numerical computation methods of welding deformation and their application in bogie frame for high-speed trains

Numerical simulation on welding stress and deformation of box structure based on similarity principles

Numberical Simulation of Welding Deformation under Different Conditions

Numerical Simulation and Development of Efficient Calculation Method for Residual Stress of SUS316 Saddle Tube-Pipe Joint

Numerical Simulation of Tungsten Inert Gas Welding of 5A12 Aluminum Alloy Limited Size Sheet

High precision modeling of welding and post welding cold rolling continuous process in numerical simulation

Numerical Analysis on Optimizing Welding Sequence of Large-Sized Bottom Structure for Controlling Welding Distortion

Three Dimension Simulation Analysis of the Interpass Stress and Deformation During Multipass Welding

Numerical Simulation Analysis of Deformation in TIG Welding of I-Steel

Numerical Analysis for Forming Limit of Welded Tube in Hydroforming

Numerical Simulation of Tube Manufacturing Consisting of Roll Forming and High-Frequency Induction Welding

Advances in numerical simulation of welding temperature field and stress and strain in structural parts

Three-Dimensional Numerical Simulation of Temperature Field and Force Field of T-Type Turbe during Welding