Abstract:CO2 blended with Ar is the most common shielding gas used for short-circuit gas metal arc welding (GMAW). There has been some technical knowledge devised from the process application over the years (personal opinion and results from practice) on the selection of the gas blend composition. However, there is still a lack of more scientific data to explain the performance of the mixtures. This paper presents a systematic study of the influence that CO2 content in mixture with Argon has on the operational performance of the short-circuit GMAW. The objectives of this study were to describe, to quantify and to explain the alterations in the metal transfer behavior, spatter generation, weld bead geometry and bead finish due to the different CO2 contents in the shielding gas. Carbon steel plates were welded in adequate parametric conditions for each CO2 + Ar shielding gas composition (CO2 ranging from 2 to 100 %). These parametric conditions were found by applying a metal transfer regularity index over welds carried out at different voltage settings for each gas blend. A target of 130 A was applied as base for comparison. Laser shadowgraphy with high-speed filming and current and voltage oscillograms were used as analysis tools. The results showed (and confirmed) that the increase of the CO2 content deteriorates metal transfer regularity, leading to excessive spatter generation and uneven bead appearance, but increases the penetration and the fusion area of the weld beads and improves bead convexity. In general, the CO2 content should neither be lower than 10 % (unless for thin plates) nor higher than 30 %.

Research progress of low spatter CO2 welding technology

Current Development and Trend of Quality Evaluation Techniques for CO2 Arc Welding Process

Achievements and Developments on Reducing Spatters in CO2 Arc Welding

Current status of research on numerical simulation of droplet transfer in CO2 gas–shielded welding

Development and Application of CO2 Welding Process

Study and Application of Process Performance and Welding Wire of CO2 Welding and MAG Welding

Microstructure and Mechanical Properties of a Weld Seam from Magnetron High-Current CO2 Welding

Research on Arc Interference Mechanism of Multi-wire CO2 Welding

Effects of Shielding Gases on Process Stability of 10crni3mov Steel in Hybrid Laser-Arc Welding

Research progress of laser welding under subatmospheric pressure

Research of IGBT Inverter Low Spatter CO2 Welding Machine

Research Status and Progress of Welding Technologies for Molybdenum and Molybdenum Alloys

Study of CO2 welding arc with and without external magnetic field

Analysis of laser induced plasma behavior and process stability in high power CO_2 laser welding of homemade ship plate

Research progress of aluminum alloy welding technology

Influence of the CO2 content on operational performance of short-circuit GMAW

Research on Droplet Size of Short-Circuiting Transfer in CO2 Gas-Shielded Arc Welding Based on High-Speed Photography

Method of Decreasing Spatter of Short-Circuit Transfer Welding

Research progress of narrow gap gas metal arc welding

Current research status and prospect of metal transfer process control methods in gas metal arc welding

Effective Control Approach on Molten Droplet Size in Waveform Controlled Short Circuit Co2 Arc Welding