Abstract:A grid-forming (GFM) inverter can effectively support active power and reactive power, and the stability problem induced by the low inertia can be thereby alleviated in a power electronics-dominated power system. Yet, the voltage source characteristic presented by the grid-forming inverter induces an overcurrent problem during a short-circuit fault. Furthermore, the time delay induces an inrush current in traditional digital control, triggered by a predefined timing sequence. To address the overcurrent problem of the GFM inverter controlled by the digital controller, the operation characteristics of GFM inverters under grid-voltage drops are investigated, and a mathematical model of the instantaneous fault current is established, which depicts the relationship between the instantaneous fault current's magnitude, grid-voltage drop severity, equivalent output impedance, and current inner-loop response speed. Then, a Set–Reset (SR) latch-based dynamic current limitation with event-triggered control is proposed for the low-voltage ride-through of the GFM inverter. In the proposed method, the current limitation is enabled during grid fault, and the active and reactive powers can be recovered rapidly after fault clearance. Meanwhile, the active and reactive power references are designed to enhance synchronization stability during the grid fault. The proposed method addresses the issue of the repeated switching of virtual impedance during grid fault and achieves rapid power recovery after fault clearance. In addition, the proposed method uses the logic of event triggers to respond to the overcurrent event in real time and realize overcurrent protection. The simulation and experimental results demonstrate the effectiveness of the proposed method in current limitation and active-power recovery after fault clearance.

Criteria for Grid-Forming Inverters Transitioning Between Current Limiting Mode and Normal Operation

Mitigation of Grid-Current Distortion for LCL-Filtered Voltage-Source Inverter With Inverter-Current Feedback Control

Cross-Forming Control and Fault Current Limiting for Grid-Forming Inverters

Current limiting strategies for grid forming inverters under low voltage ride through

Dynamic Current-Limitation Strategy of Grid-Forming Inverters Based on SR Latches

Transient Stability Enhancement of Current Limited-GFM Inverters Based on Varying Virtual Impedance

Study on the Over-Voltage and Over-Current of Grid-Connected Inverters in Non-Fault Conditions

On the Transient Overcurrent Mechanism of Grid Forming Converter in Fault Recovery Stage

An Adaptive Current-Limiting Strategy for Grid-Forming Converters under Grid Faults

Modeling Fault Recovery and Transient Stability of Grid-Forming Converters Equipped With Current Reference Limitation

Robustness Evaluation for Harmonic Suppression of LCL-type Converter Based on Converter-Side Current Feedback Strategy under Weak and Distorted Grid

A General Current Limiting Strategy of Grid-Forming Converters Based on Adaptive Virtual Impedance Regulated by Fuzzy PI Control

Multiple Loops of Current-Limiting Control for Grid-forming Inverters in the Overload Conditions

Adaptive low voltage crossing strategy for symmetrical faults of networked inverters

Voltage Support Capability Analysis of Grid-Forming Inverters with Current-Limiting Control Under Asymmetrical Grid Faults

An Adaptive Virtual-Impedance-Based Current-Limiting Method with the Functionality of Transient Stability Enhancement for Grid-Forming Converter

Control Stratories for Grid-Connected and Island Dualmode Operated Inverter under Unbalanced Grid Voltage Conditions

A novel control method for dual mode time-sharing grid-connected inverter

Linearization Equivalent Model Study of IIDG Fault Output with Low Current Limiting

L- and LCL-Filtered Grid-Tied Single-Phase Inverter Transistor Open-Circuit Fault Diagnosis Based on Post-Fault Reconfiguration Algorithms