Abstract:A grid-forming (GFM) inverter can effectively support active power and reactive power, and the stability problem induced by the low inertia can be thereby alleviated in a power electronics-dominated power system. Yet, the voltage source characteristic presented by the grid-forming inverter induces an overcurrent problem during a short-circuit fault. Furthermore, the time delay induces an inrush current in traditional digital control, triggered by a predefined timing sequence. To address the overcurrent problem of the GFM inverter controlled by the digital controller, the operation characteristics of GFM inverters under grid-voltage drops are investigated, and a mathematical model of the instantaneous fault current is established, which depicts the relationship between the instantaneous fault current's magnitude, grid-voltage drop severity, equivalent output impedance, and current inner-loop response speed. Then, a Set–Reset (SR) latch-based dynamic current limitation with event-triggered control is proposed for the low-voltage ride-through of the GFM inverter. In the proposed method, the current limitation is enabled during grid fault, and the active and reactive powers can be recovered rapidly after fault clearance. Meanwhile, the active and reactive power references are designed to enhance synchronization stability during the grid fault. The proposed method addresses the issue of the repeated switching of virtual impedance during grid fault and achieves rapid power recovery after fault clearance. In addition, the proposed method uses the logic of event triggers to respond to the overcurrent event in real time and realize overcurrent protection. The simulation and experimental results demonstrate the effectiveness of the proposed method in current limitation and active-power recovery after fault clearance.

Current limiting strategies for grid forming inverters under low voltage ride through

Transient Voltage Stability Analysis and Enhancement of Grid-Following Converters Considering Current Limitation

Dynamic Current-Limitation Strategy of Grid-Forming Inverters Based on SR Latches

A Low-Voltage Ride-Through Control Strategy for Three-Phase Grid-Connected Pv Systems

Cross-Forming Control and Fault Current Limiting for Grid-Forming Inverters

Adaptive low voltage crossing strategy for symmetrical faults of networked inverters

Transient Stability Enhancement of Current Limited-GFM Inverters Based on Varying Virtual Impedance

A Novel Fault Ride Through Strategy for Grid-Connected Virtual Synchronous Generators: Power Angle Stability Enhancement and Current Limiting

An Adaptive Current-Limiting Strategy for Grid-Forming Converters under Grid Faults

An Improved Current-Limiting Control Strategy of Grid-Forming Inverter During Grid Fault

Study on the Over-Voltage and Over-Current of Grid-Connected Inverters in Non-Fault Conditions

Active Power Enhancement Control Strategy of Grid-Forming Inverters Under Asymmetrical Grid Faults

Enhancement of Withstand Capability of Grid-Tied Inverters during transients, utilizing dc-side magnitudes

Transient stability improvement of grid-forming voltage source converters considering current limitation

Control strategy for current limitation and maximum capacity utilization of grid connected PV inverter under unbalanced grid conditions

Multiple Loops of Current-Limiting Control for Grid-forming Inverters in the Overload Conditions

Criteria for Grid-Forming Inverters Transitioning Between Current Limiting Mode and Normal Operation

Dynamic Current Limiting of Grid-forming Converters for Transient Synchronization Stability Enhancement

A Review of Recent Requirements for Inverter-Based Resources and Grid-Forming Technologies

An Adaptive Virtual-Impedance-Based Current-Limiting Method with the Functionality of Transient Stability Enhancement for Grid-Forming Converter