Abstract:Due to the energy crisis and environmental pollution, the installed capacity of inverter-based resources (IBRs) in power grids is rapidly increasing, and grid-following control (GFL) is the most prevalent at present. Meanwhile, grid-forming control-based (GFM) devices have been installed in the grid to provide active support for frequency and voltage. In the future GFL devices combined with GFM will be promising, especially in power systems with high penetration or 100% IBRs. When a short-circuit fault occurs in the grid, the controlled current source characteristic of the GFL devices leads to insufficient dynamic voltage support (DVS), while the GFM devices usually reduce the internal voltage to limit the current. Thus, deep voltage sags and undesired disconnections of IBRs may occur. Moreover, due to the dispersed locations and the control strategies' diversity of IBRs, the voltage support of different devices may not be fully coordinated, which is not conducive to short-term voltage security (STVS). To address this issue, a control scheme based on the simulation of transient characteristics of synchronous machines (SMs) is proposed. Then, a new fault ride-through strategy (FRT) is proposed based on the characteristic differences between GFL and GFM devices, and an optimization model of multi-device control parameters is formulated to meet the short-term voltage security constraints (SVSCs) and device capacity constraints. Finally, a fast solution method based on analytical modeling is proposed for the model. Test results based on the doublegenerator-one-load system, the IEEE 14-bus system, and other systems of different sizes show that the proposed method can effectively enhance the active support capability of GFL and GFM to the grid voltage, and avoid the large-scale disconnection of IBRs

A Review of Recent Requirements for Inverter-Based Resources and Grid-Forming Technologies

Grid‐forming control for inverter‐based resources in power systems: A review on its operation, system stability, and prospective

Fault Ride-Through Control of Grid-Connected Photovoltaic Power Plants: A Review

Reviewing Control Paradigms and Emerging Trends of Grid-Forming Inverters—A Comparative Study

Grid-Forming Converters: Control Approaches, Grid-Synchronization, and Future Trends—A Review

Extended Characteristics of Grid-Forming Control: Seen from the Perspective of AC Power Supply

Assessing Grid Strength of 100% Inverter-Based Power Systems

Analysis and Benchmarking of Grid-Forming Control for Power Converters

Guest Editorial: Grid‐forming Converters Placement and Utilisation to Enhance Transmission and Distribution Performances under High Penetration of Inverter‐based Resources

Review of Grid-forming Inverters in Support of Power System Operation

Review of Photovoltaic–Battery Energy Storage Systems for Grid-Forming Operation

Grid Forming Converters in Renewable Energy Sources Dominated Power Grid: Control Strategy, Stability, Application, and Challenges

High Share Participation of Grid-Forming InverterBased Resources in Grid Frequency and Voltage Support

A Review of Control Techniques for Inverter-Based Distributed Energy Resources Applications

Active Support of Inverters for Improving Short-Term Voltage Security in 100% IBRsPenetrated Power Systems

Evaluating Frequency Stability with a Generic Model for IBR Penetration and the Implementation of Grid-Forming Control Strategies

Grid‐forming converters in interconnected power systems: Requirements, testing aspects, and system impact

Current Reference Optimization for Inverter-Based Resources to Mitigate Grid Voltage Unbalance Factor

A Strong-Grid-Friendly Voltage Control Method of Grid-Forming Inverters

A Review on Low Voltage Ride-through Technologies and Prospect for DFIG Wind Turbines

Grid-Forming Control Based On Emulated Synchronous Condenser Strategy Compliant With Challenging Grid Code Requirements